TR20 Remote Control
SPECIFICATION and INSTRUCTION SHEET DESCRIPTION:
One Ceiling Fan and Light, 3 Speed, Reversing Remote Control
FAN MODEL USED:
See Catalog or visit our website
www.fanimation.com
for more information
How to Wire and Operate Your TR20 Transmitter
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a quali fi ed electrician.
Remote Transmitter Unit Detail Receiver Unit Detail
WARNING
To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be
grounded for safe operation. 1. Setting the Code:
Multiple The remote unit has 16 different code combinations. It may be necessary to test a couple frequency code settings to improve signal reception and/or eliminate interference from other remote control household items. fans should have different code settings to allow independent fan control. T o set the code, perform these steps.
2. Transmitter:
remove battery cover. Press firmly below arrow and slide battery cover off. Slide code switches to your choice of up or down position. Factory setting is all up. Do not use this position. the transmitter.
3. Receiver:
With a small screwdriver or ball point pen slide firmly up or down (Figure 1a). Replace battery cover on Slide code switches to the same positions as set on your transmitter (Figure 1b).
4. Operating & Using Remote Transmitter (Figure 2):
Remove the plastic wrapping from the enclosed battery.
Install two piece of 3 volt battery
(If not using for long periods of time, remove battery to prevent damage to transmitter). Store the transmitter away from excess heat or humidity. • HI Push Button – high fan speed • MED Push Button – medium fan speed • LOW Push Button – low fan speed air downflow • Push Button – fan off • LIGHT Push Button – toggles between light on or light off, also works as light dimmer (see note*) (if optional light kit or fitter is used)
NOTE: To control either light hold down key to increase or decrease brightness. Tap key quickly to turn light on or off. The light keys have auto resume and will stay at the same brightness as the last time it was turned off.
Figure 1a Figure 1b
WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until the blades is in place. Noise and fan damage could result.
3V, CR2032 BATTERY 2 PCS
Figure 2
How to Install Your Remote Control (Option #1)
1.
Unthread two screws from the wall switch plate.
(Figure 1)
2.
Install the control bracket with two #6-32x 3/4” screws.
And push the four plastic plug to cover the screw holes.
(Including in the control).(Figure 2)
Figure 1 Figure 2
How to Install Your Remote Control (Option #2)
1.
Unthread two screws from the wall switch plate.
(Figure 1)
2.
Install the control bracket with two #6-32x 1” screws.
And push the four plastic plug to cover the screw holes.
(Including in the control).(Figure 2)
Figure 1 Figure 2
How to Install Your Remote Control (Option #3)
1.
Drill the two 1/4” holes in wall and use the M6 plastic anchor pushed into the holes. Install the control bracket with two #3- 1” self tap screws. Push the four plastic plug to cover the screw holes. (Including in the control).
(Figure 1)
Figure 1
Copyright 2011 Fanimation 2011/01
