LIMITED WARRANTY

All equipment which is sold under ANVIL trademark and used for commercial purposes is warranted against defects in materials and workmanship. The warranty runs for two years from the date of original installation and is for the benefit of the original purchaser only. All other Warranties ,expressed or implied , statutory or otherwise, including without limitations any implied Warranty of Merchantability or fitness for purpose are excluded .The Seller shall in no event be liable for direct,indirect or consequential damages in connection with ANVIL commercial products.

The Sellers obligation under this Warranty is limited to the repair of defects without charge. Defective units must be taken or shipped,transportation charges prepaid,to ANVIL.

This Warranty is not effective if damage occurs because of accident,carelessness,improper installation,lack of proper set-up,supervision when required or if the equipment is installed or operated in any manner contrary to the installation and operating instructions. In these cases,repairs will be made at a reasonable cost. Work performed by unauthorized personnel or unauthorized service agencies using non Anvil spares voids this Warranty. NB:

REGISTER ON-LINE TODAY

Register your warranty on-line now at www.anvilworld.com

NO WEB ACCESS

If you do not have access to the Web. Kindly register by completing the warranty registration form and fax it to the ANVIL office in the country of purchase.

Failure to do so will invalidate your warranty.

4-INS-CWA0002

COFFEE JUG WARMER

INSTALLATION OPERATION AND CARE OF COFFEE JUG WARMER MODELS: CWA0002 R02

1

UNPACKING

Unpack the product and check for any damage incurred during transit. This should be reported to the responsible carrier, railway or postal authority, and a request for a damage report should be made.

THESE INSTRUCTIONS MUST BE FOLLOWED FOR US TO GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM FOR PROTECTING AGAINST LOSS FROM CONCEALED DAMAGE. THE FORM FOR FILING SUCH A CLAIM WILL BE PROVIDED BY THE CARRIER.

GENERAL INSTALLATION AND OPERATION INSTRUCTIONS

1. Select either one or two plate operation as required using the illuminated switches provided.

2. The unit has been designed to run continuously. 3. The plate area of the warmer is a hot surface. Only Pyrex and or stainless steel decanters should be used.

10

9

WARNING

Burn Hazard

.

Do not touch hot food,liquid or heating surfaces while equipment is heating or operating Hot surfaces and food can burn skin. Allow the hot surfaces to cool before handling

CLEANING

1. Always ensure that the appliance is disconnected from the mains power supply before cleaning.

2. This appliance should not be cleaned with a water jet or immersed in water. Use only a damp cloth or sponge dipped in soapy water.

3. Wipe off the appliance with a dry cloth and wait at least half an hour before re – connecting to the mains outlet. 2 THIS APPLIANCE SHOULD NOT BE CLEANED WITH A WATER JET OR IMMERSED IN WATER. USE ONLY A DAMP CLOTH OR SPONGE DIPPED IN SOAPY WATER. DO NOT USE STEEL-WOOL WHICH WILL MARK THE BRIGHT STAINLESS STEEL FINISH CLEAN THE STAINLESS STEEL PARTS WITH WATER AND SOAP. AVOID THE USE OF DETERGENTS CONTAINING ABRASIVE SUBSTANCES. ALWAYS RINSE WELL AND DRY CAREFULLY AFTER CLEANING. DO NOT USE PRODUCTS CONTAINING AGGRESSIVE CHEMICALS, ACIDS OR PRODUCTS WITH CHLORINE TO CLEAN THE STAINLESS STEEL EVEN IF DILUTED

3

WARNING

Electric Shock Hazard

.

Keep water and other liquids from entering the inside of the equipment. Liquid inside the equipment could cause an electrical shock Do not spray water or cleaning products. Liquid could contact the electrical components and cause a short circuit or an electrical shock. Do not use equipment if power cord is damaged or has been modified

SAFETY READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO YOURSELF AND OTHERS

1. When this appliances is to be positioned in close proximity to a wall, partitions, kitchen furniture, decorative finishes, etc. it is recommended that they be made of non-combustible material. If not, they shall be clad with a suitable non-combustible heat insulating material, and the closest attention be paid to fire prevention regulations.

2. Use the appliances on an individual 15A mains outlet only.

DO NOT OVERLOAD THE CIRCUIT.

come into contact with hot surfaces.

proximity to children.

with local codes and ordinances.

8. Use equipment in a flat level position.

9. Do not operate unattended tioning in any way.

(A.C.) 3. Ensure that the equipment and the power supply cord does not 4. Supervision is necessary when the appliance is used in close 5. If the supply cord is damaged, it must be replaced with a new cord assembly available from the suppliers agent.

6. Use only earthed outlets matching the serial plate voltage.

7. Have equipment installed by a qualified personnel in accordance 10. The equipment may be hot, even though the pilot light is not on.

11. Do not operate if equipment has been damaged or is malfunc 12. These appliances are designed to run only on alternating current

DO NOT CONNECT TO DIRECT CURRENT (D.C)

COFFEE JUG WARMER MODEL CODE :CWA0002 RO2

Part No.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Description

COFFEE WARMER CASTING BODY ASSEMBLY BOTTOM COVER ILLUMINATED ROCKER SWITCH ANVIL AXIS LOGO SMALL FOOT ELEMENT CLAMP PLATE ELEMENT HOLDER BOTTOM MILL BOARD ELEMENT 230V 60W ELEMENT HOLDER TOP ELEMENT PROTECTION COVER TERMINAL BLOCK CABLE GRIP POWER CORD 8

COFFE WARMER TWO PLATE MODEL CODE:CWA0002 R02

EXPLODED DIAGRAM COFFEE JUG WARMER MODEL: CWA0002 R02

7

POSITIONING DIAGRAM COFFEE JUG WARMER MODEL: CWA0002 R02

4

84mm

ELECTRICAL CONNECTION INFORMATION

MODEL DESCRIPTION CWA0002 COFFEE JUG WARMER CWA0002-120 COFFEE JUG WARMER VOLTS (V /Hz) 230/50 230/50 POWER (W) 200 200 5 IT IS ESSENTIAL TO MAKE SURE THAT THE INCOMING VOLTAGE IS THE SAME AS THE RATED VOLTAGE OF THE OF THE UNIT AS FOUND ON THE SERIAL PLATE. THE SERIAL PLATE IS LOCATED AT THE REAR OF THE UNIT ADJACENT TO THE INCOMING CABLE ENTRY.

WIRING DIAGRAM COFFE JUG WARMER MODEL CODE: CWA0002 R02

LEGEND S1 S2 E1/E2 DESCRIPTION ILLUMINATED ROCKER SWITCH ILLUMINATED ROCKER SWITCH ELEMENT 100W/230V PART NUMBER 1-17TAF 1-17TAF 5-COFFEE WARMER WIRING DIAGRAM 6 N 230V E1 S1 L E E2 S2 MODEL: COFFEE WARMER TWO PLATE SLIMLINE - 230V MODEL CODE: CWA0002 LEGEND DESCRIPTION S1 S2 E1/E2 ILLUMINATED ROCKER SWITCH PLATE 1 ILLUMINATED ROCKER SWITCH PLATE 2 ELEMENT COFFEE WARMER - 100W / 230V MODEL: COFFEE WARMER TWO PLATE SLIMLINE - 120V MODEL CODE: CWA0002-120 LEGEND S1 S2 E1/E2 DESCRIPTION ILLUMINATED ROCKER SWITCH PLATE 1 ILLUMINATED ROCKER SWITCH PLATE 2 ELEMENT COFFEE WARMER - 100W / 120V PART NUMBER 1 - 17TAF 1 - 17TAF 5 - COFFEEWARMER PART NUMBER 1 - 17TAF 1 - 17TAF 5 - 120V - 100W - CW