PIE WARMER

LIMITED WARRANTY

All equipment which is sold under ANVIL trademark and used for commercial purposes is warranted against defects in materials and workmanship. The warranty runs for two years from the date of original installation and is for the benefit of the original purchaser only. All other Warranties ,expressed or implied , statutory or otherwise, including without limitations any implied Warranty of Merchantability or fitness for purpose are excluded .The Seller shall in no event be liable for direct,indirect or consequential damages in connection with ANVIL commercial products.

The Sellers obligation under this Warranty is limited to the repair of defects without charge. Defective units must be taken or shipped,transportation charges prepaid,to ANVIL.

This Warranty is not effective if damage occurs because of accident,carelessness,improper installation,lack of proper set-up,supervision when required or if the equipment is installed or operated in any manner contrary to the installation and operating instructions. In these cases,repairs will be made at a reasonable cost. Work performed by unauthorized personnel or unauthorized service agencies using non Anvil spares voids this Warranty. NB:

REGISTER ON-LINE TODAY

Register your warranty on-line now at www.anvilworld.com

NO WEB ACCESS

If you do not have access to the Web. Kindly register by completing the warranty registration form and fax it to the ANVIL office in the country of purchase.

Failure to do so will invalidate your warranty.

4-INS-PWK0007

INSTALLATION OPERATION AND CARE OF PIE WARMER MODELS: PWK0007 R04 / PWA1007 R01

1

UNPACKING

Unpack the product and check for any damage incurred during transit. This should be reported to the responsible carrier, railway or postal authority, and a request for a damage report should be made.

THESE INSTRUCTIONS MUST BE FOLLOWED FOR US TO GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM FOR PROTECTING AGAINST LOSS FROM CONCEALED DAM AGE. THE FORM FOR FILING SUCH A CLAIM WILL BE PROVIDED BY THE CARRIER.

GENERAL INSTALLATION AND OPERATION INSTRUCTIONS

1. This unit has been designed for countertop display of food such as pies and sausage rolls . The heater system ensures that the products placed inside can be stored and served at the correct temperature and humidity. An internal lighting system enhances the products displayed.

2. There are three wire shelves provided with the unit. The wire shelves must be positioned with the four legs inside the support runner this prevents the shelf from sliding forward or backward.

3. Install the unit in the most convenient location for the ease of cleaning, maintenance and point of sale of display.

4. The temperature is manually controlled.

5. The unit has a temperature gauge to monitor the temperature inside the unit.

6. There is a removable crumb tray positioned at the front of the unit.

NOTES 14

MODEL: PIE WARMER 450 MODEL CODE :PWA1007 REV.0

26 27 28 29 30 31 32 33 34 35 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Part No.

1

Description

LID PANEL TOP GLASS BODY ASS WIRE COVER ANGLE COOL WHITE 14W ENERGY SAVER PORCELAIN LAMP HOLDER DOOR MAGNET BUSH DOOR HINGE DOOR GLASS ELEMENT MOUNTING BRACKET GASSTRONORM CONTAINER WATER DISH HOLDER TOP GLASS DISPLAY DOOR HANDLE BACK DOOR HANDLE DOOR KNOB CONTROL PANEL PILOT LIGHT CONTROL KNOB INDICATING THERMOMETER ROCKER SWITCH THERMOSTAT CABLE STRAIN FEET ELEMENT BRACKET SUPPORT 1500W ELEMENT POWER CORD BASE COVER SHELF CRUMB TRAY L/H FRONT ANGLE GLASS R/H FRONT ANGLE GLASS SHELF RUNNER FRONT GLASS 13 2

SPECIFIC OPERATING INSTRUCTIONS

1. The unit is provided with a small humidity pan and mount ed in the internal bottom plate. Should humidity be required this must be filled with 600 ML of water and the level must be monitored on a regular basis.

2. For servicing, the unit is provided with a removable bottom panel. 3. For changing the top light bulb, the four screws holding the top lid must be removed. Lift off the lid and the light fitting is accessible.

4. For ease of cleaning remove Gastronorm container.

WARNING

Burn Hazard

.

Do not touch hot food,liquid or heating surfaces while equipment is heating or operating Hot surfaces and food can burn skin. Allow the hot surfaces to cool before handling

CLEANING

1. Always ensure that the unit is disconnected from the mains power supply before cleaning 2. This appliance should not be cleaned with a water jet or im mersed in water. Use only a damp cloth or sponge dipped in soapy water.

3. Wipe off the unit with a dry cloth and wait at least half an hour before re – connecting to the mains outlet. 3 THIS APPLIANCE SHOULD NOT BE CLEANED WITH A WATER JET OR IMMERSED IN WATER. USE ONLY A DAMP CLOTH OR SPONGE DIPPED IN SOAPY WATER. DO NOT USE STEEL-WOOL WHICH WILL MARK THE BRIGHT STAINLESS STEEL FINISH

EXPLODED DIAGRAM PIE WARMER 450MM WIDE MODEL: PWA1007 R00 MODEL: PWA1007 REV.0

12

WIRING DIAGRAM PIE WARMER 450MM WIDE MODEL CODE: PWA1007 R00

LEGEND S1 B1 H1 E1 H2 DESCRIPTION ROCKER SWITCH THERMOSTAT INTERIOR LIGHT ELEMENT 750W/230V PILOT LIGHT N 230V L E1 S1 H1 B1 H2 E 11 4 PART NUMBER 1-RS-NI 1-THER-PWK0001 1-LB-PWA0001 5-1500-PWA0001 1-PL-BMA0001

WARNING

Electric Shock Hazard

.

Keep water and other liquids from entering the inside of the equipment. Liquid inside the equipment could cause an electrical shock Do not spray water or cleaning products. Liquid could contact the electrical components and cause a short circuit or an electrical shock. Do not use equipment if power cord is damaged or has been modified

SAFETY REV.0

READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO YOURSELF AND OTHERS

LEGEND

B1 E1 S1 H1 H2

DESCRIPTION PART NUMBER

to a wall, partitions, kitchen furniture, decorative finishes, etc. it is recommended that they be made of non-combustible mate rial. If not, they shall be clad with a suitable non-combustible heat insulating material, and the closest attention be paid to fire prevention regulations.

2. Do not operate without the crumb tray, as it will cause burn marks on the counter top.

3. Use the appliances on an individual 15A mains outlet only.

DO NOT OVERLOAD THE CIRCUIT.

4. Ensure that the equipment and the power supply cord does not come into contact with hot surfaces.

5. Supervision is necessary when the appliance is used in close proximity to children.

6. If the supply cord is damaged, it must be replaced with a new cord assembly available from the suppliers agent.

7. Use only earthed outlets matching the serial plate voltage.

8. Have equipment installed by a qualified person in accordance with local codes and ordinances.

9. Use equipment in a flat level position.

10. The equipment may be hot, even though the pilot light is not on.

11. Do not operate if equipment has been damaged or is malfunc tioning in any way.

12. These appliances are designed to run only on alternating current (A.C.)

DO NOT CONNECT TO DIRECT CURRENT (D.C)

ELECTRICAL CONNECTION INFORMATION

MODEL PWK0007 PWA1007 DESCRIPTION PIE WARMER MINI PIE WARMER 450 WIDE VOLTS (V/Hz) 230V/50Hz 230V/50Hz POWER (W) 750 1500 5 IT IS ESSENTIAL TO MAKE SURE THAT THE INCOMING VOLTAGE IS THE SAME AS THE RATED VOLTAGE OF THE UNIT AS FOUND ON THE SERIAL PLATE. THE SE RIAL PLATE IS LOCATED AT THE REAR OF THE UNIT ADJACENT TO THE INCOMING CABLE ENTRY.

POSITIONING DIAGRAM PIE WARMER 450MM WIDE MODEL: PWA1007

453 10

MODEL: PIE WARMER MINI MODEL CODE :PWK0007 R04

Part No.

1 20 21 22 23 24 25 26 27 6 7 8 2 3 4 5 9 10 11 12 13 14 15 16 17 18 19

Description

TOP COVER INNER GLASS COOL WHITE ENERGY SAVER LIGHT BULB PORCELAIN LAMP HOLDER DISPLAY GLASS GASTRONORM PAN GASTRONORM HOLDER HINGE BUSH, HINGE AND MAGNET SET DOOR CATCH DOOR HANDLE FRONT GLASS DOOR KNOB PILOT LIGHT FASCIA PANEL ROCKER SWITCH TEMPERATURE GAUGE CABLE RELIEF ELEMENT FOOT BOTTOM COVER THERMOSTAT POWER CABLE ANGLE SHELF OUTER ENCLOSRE CRUMB TRAY SHELF RUNNER FRONT GLASS 9

POSITIONING DIAGRAM PIE WARMER MINI MODEL: PWK0007

353 6

WIRING DIAGRAM PIE WARMER MODEL CODE: PWK0007 R02

LEGEND S1 B1 H1 E1 H2 DESCRIPTION ROCKER SWITCH THERMOSTAT INTERIOR LIGHT ELEMENT 750W/230V PILOT LIGHT N 230V L E PART NUMBER 1-RS-NI 1-THER-PWK0001 1-LB-PWA0001 5-750-PWA0002 1-PL-BMA0001 7 S1 H1 E1 B1 H2

LEGEND B1 E1 S1 H1 H2

EXPLODED DIAGRAM PIE WARMER MODEL: PWK0007 R04

DESCRIPTION CONTROL THERMOSTAT ELEMENT 750W LIGHT SWITCH LIGHT CONTROL PILOT LIGHT PART NUMBER 1-THERMO-TO-TEF 5-750W-PWA0002 1-RS-NI 1-LB-PWA0001 1-PL-BMA0001

8