Legrand Clarity 6 hinged 24-port panel Assembly Instructions

 DO о оо о со ос сео
ERC
UN
o
7
NOOO о о < < о о <
ORTRONICS
@ 125 EUGENE O'NEILL DRIVE TITLE
NEW LONDON, CT 06320
TEL: 860—445—3800
FAX: 860—405—2990
RAISED FLOOR BRACKET KIT
ASSEMBLY INSTRUCTIONS
;
\
< с с сс < ос с се с сс
S ss
=
\\ 99959999999
SEISMIC INSTALLATION REQUIRMENTS SHOULD BE APPROVED
BY A LICENSED STRUCTURAL ENGINEER.
COMPLIANCE WITH ALL STATE AND LOCAL BUILDING CODES
ARE THE RESPONSIBILITY OF THE INSTALLER.
| o O o O
0 EQUIPMENT RACK— © © © eo Il
O O о O
| о! lo ||
о SEE NOTE 9 о
O — — O
О OS O
Es == C
A ‚Ир ET OS
= “ — — — — — — — — — — — — — — — — — —
RASED LR 7777777777777 7772220
SUB FLOOR
ITEM | QUAN DESCRIPTION
1 | 4 | ANCHOR BOLTS
1. PLACE ASSEMBLED EQUIPMENT RACK WHERE IT WILL BE PERMANENTLY LOCATED. 214 5/8-11 THREADED ROD
2. MARK THE RAISED FLOOR THROUGH THE BASE ANGLE MOUNTING HOLES. -
3. DRILL 2%,” DIA. HOLES THROUGH THE RAISED FLOOR. 3 | 20 | 5/8" SPLIT LOCK WASHERS
4. MARK THE SUB—FLOOR DIRECTLY BELOW THE CENTER OF THE DRILLED HOLES. 4 | 20 | 5/8-11 HEX NUTS
5. DRILL 27%,” DIA. HOLES A MINIMUM OF 2 %s” DEEP IN THE SUB-FLOOR. 514 5/8" FLAT WASHERS
6. CLEAN HOLE AND INSTALL ANCHOR USING PROPER SETTING TOOL(HILTI P/N 00032981)
OR EQUIVILENT. TOOL NOT SUPPLIED. 6| 2 BRACKET, SIDE TO SIDE
7. SCREW THREADED RODS INTO THE ANCHORS TO A DEPTH OF APROX. 7%”. 7| 2 BRACKET, FRONT TO REAR
8. FOLLOW THE ABOVE VIEWS FOR ASSEMBLY ORDER.
9. SAW OR CUT OFF EXCESS ROD, 34” TO %” ABOVE THE TOP NUT, AS SHOWN.
INSTRUCTION SHEET NUMBER | REV ECN SHEET DWN.BY: DATE CHK.BY: DATE APP.BY: DATE
OR-71601375 01 02357 1 of 1 D. Bogue 03/18/03