Aad
dies
& ORTRONICS
e 125 EUGENE O'NEILL DRIVE
NEW LONDON, CT 06320
TEL: 860—445—3800
FAX: 860—405—2990
TITLE
RAISED FLOOR BRACKET KIT
ASSEMBLY INSTRUCTIONS
4—MATION RACKS
VALES
\
\
ge
/ M
7
SEISMIC INSTALLATION REQUIRMENTS SHOULD BE APPROVED
BY A LICENSED STRUCTURAL ENGINEER.
COMPLIANCE WITH ALL STATE AND LOCAL BUILDING CODES
ARE THE RESPONSIBILITY OF THE INSTALLER.
| 7 = = N. ° EQUIPMENT RACK— e © © ol
~
„” | o SEE NOTE 9 © |
о — o
O = == ст == —=Z === == O
| 4
|| — 3
] О 5
2
3
6 ET Pre
7
10° A
SUB FLOOR ¿ 4a TIT) p
| Ш.
| |
ÍTEM | QUAN DESCRIPTION
1 | 4 | ANCHOR BOLTS
1. PLACE ASSEMBLED EQUIPMENT RACK WHERE IT WILL BE PERMANENTLY LOCATED 2 | 4 | 5/811 THREADED ROD
2. MARK THE RAISED FLOOR THROUGH THE BASE ANGLE MOUNTING HOLES. 3 | 20 | 5/8" SPLIT LOCK WASHERS
3. DRILL 2%," DIA. HOLES THROUGH THE RAISED FLOOR. 4 | 20 | 5/8-11 HEX NUTS
4. MARK THE SUB—FLOOR DIRECTLY BELOW THE CENTER OF THE DRILLED HOLES. 5 | 4 | 5/8" FLAT WASHERS
5. DRILL 2%," DIA. HOLES A MINIMUM OF 2 %e” DEEP IN THE SUB—FLOOR. = Bracke SIDE 10 SDE
6. CLEAN HOLE AND INSTALL ANCHOR USING PROPER SETTING TOOL(HILTI P/N 00032981)
OR EQUIVILENT. TOOL NOT SUPPLIED. 7 | 2 | BRACKET, FRONT TO REAR
7. SCREW THREADED RODS INTO THE ANCHORS TO A DEPTH OF APROX. %4”.
8. FOLLOW THE ABOVE VIEWS FOR ASSEMBLY ORDER.
9. SAW OR CUT OFF EXCESS ROD, %” TO %” ABOVE THE TOP NUT, AS SHOWN.
INSTRUCTION SHEET NUMBER | REV | ECN SHEET DWN.BY: DATE CHK.BY: DATE APP.BY: DATE
OR-71601413 00 1 of 1 D. Bogue 12/15/03 JIM LUCY 12/29/03 MEM 12/29/03
">
