& ORTRONICS
@ 125 EUGENE O'NEILL DRIVE
NEW LONDON, CT 06320
TEL: 860—445—3800
FAX: 860—405—2990
TITLE
RAISED FLOOR BRACKET KIT
ASSEMBLY INSTRUCTIONS
16.25” RACKS
< се ес ее ©
RAISED FLOOR
SEISMIC INSTALLATION REQUIRMENTS SHOULD BE APPROVED
BY A LICENSED STRUCTURAL ENGINEER.
COMPLIANCE WITH ALL STATE AND LOCAL BUILDING CODES
ARE THE RESPONSIBILITY OF THE INSTALLER.
о
оо
00
о
oO
| o © I
o
00
SEE NOTE 9
4
3——
5
3
4
4
3
6 6
3
4 7 4
4 7 3
3
1 [ZZ | 1
hm 4 ri
SUB FLOOR à 4 IM a 4 | ИН
|| 4 J || -
TEM | QUAN DESCRIPTION
1 | 4 | ANCHOR BOLTS
1. PLACE ASSEMBLED EQUIPMENT RACK WHERE IT WILL BE PERMANENTLY LOCATED 2| 4 | 5/811 THREADED ROD
2. MARK THE RAISED FLOOR THROUGH THE BASE ANGLE MOUNTING HOLES. 3 | 20 | 5/8" SPLIT LOCK WASHERS
3. DRILL 2%,” DIA. HOLES THROUGH THE RAISED FLOOR. 4 | 20 | 5/8-11 HEX NUTS
4. MARK THE SUB—FLOOR DIRECTLY BELOW THE CENTER OF THE DRILLED HOLES. 5 | 4 | 5/8 FLAT WASHERS
5. DRILL 2%,” DIA. HOLES A MINIMUM OF 2 %s” DEEP IN THE SUB—FLOOR.
6. CLEAN HOLE AND INSTALL ANCHOR USING PROPER SETTING TOOL(HILTI P/N 00032981) 6 | 2 | BRACKET, SIDE TO SIDE
OR EQUIVILENT. TOOL NOT SUPPLIED. 7 | 2 | BRACKET, FRONT TO REAR
7. SCREW THREADED RODS INTO THE ANCHORS TO A DEPTH OF APROX. 7”.
8. FOLLOW THE ABOVE VIEWS FOR ASSEMBLY ORDER.
9. SAW OR CUT OFF EXCESS ROD, 3%” TO %” ABOVE THE TOP NUT, AS SHOWN.
INSTRUCTION SHEET NUMBER | REV | ECN SHEET DWN.BY: DATE CHK-BY: DATE APP.BY: DATE
OR-71601381 00 1 of 1 D. Bogue 04/01/03
">
