Everlast 2260 Reflex Bag Product Manual

 Everlast Worldwide, 1900 Hwy DD, Moberly, MO 65270
VERL A 2260 ADVANCED REFLEX BAG
, ASSEMBLY INSTRUCTIONS
<< TEL: 1.800.821.7930 FAX 660.263.0703 092412
All tools required for assembly included
STEP1.
OVE RVI EW CHART Open the Cap (B) on the Base (A) and fill with water
(Figure A) or sand (Figure B) and close with Cap (B) .
STEP2.
Attach Spring (E) to the top of Base (A)
with four Screws (F) and tighten.
STEP3.
Loosen Knob (H) and slide Inner Tube (1) into Outer Tube
(G) and tighten Knob (H) . Slide tube assembly into spring
assembly.
STEP4.
Slide Foam Cover (D) onto Inner Tube (1) past mounting
holes. Attach Ball (L) to Inner Tube (1) with two Screws (J)
and Nuts (K) and tighten. Slide Foam Cover (D) up over
screws.
STEPS.
Use Knob (H) to adjust tube assembly height as desired .
WARNING:
H The EVERLAST Reflex Bag is not a toy. Please do not allow
children to use it without adult supervision. Similarly, before
allowing people unfamiliar with the reflex bag to use it,
instruct them on the basics. The user must accept full
G— responsibility for the safe and proper assembly and
use of all equipment. Before each and every use be sure the
equipment is in good condition and properly fastened.
C FIGURE A FIGURE B
m
For Consumer Use Only