SERVICE INSTRUCTIONS
TL-CB20
SI-8200B
Easy Set Tool
Before use, read these instructions carefully, and follow
them for correct use.
How to use the easy set tool
1 Loosen the cable adjusting bolt at the brake
* lever so that there is sufficient clearance for
the brake shoes,
Cable adjusting bolt
Secure the cable as shown in the illustration.
" Check that the angle between the link wire
and the cable is correct at this time.
Tightening torque:
6 — 8 Nm {53 — 69 In. Ibs.}
3 Attach the easy set tool and then install the
" brake shoes in the correct positions.
Shoe clearance is not needed
Attach to the shoe fixing pins
Tightening torque: — ”
. 8-9 Nm {70-78 in. Ibs.}
4 Turn the cable adjusting bolt clockwise to
" make some clearance between the shoes
and the rim.
Cable adjusting bolt
Shoe clearance
5 Turn the spring tension adjustment screw so
* that the cable carrier comes to a position
directly below the outer casing holder.
(== O
A Outer casing holder
20 mm or more
Spring tension adjustment screw
e Please nole: Specifications are subject to change for improvement
without notice. (English)
ES
This service Inslruchons 15
printed on recycled paper
and can be recycled again
SHIMANO
SHIMANO AMERICAN CORPORATION
One Shimano Drive, PO. Box 19615, Irvine, Caldera U S A 22F 10-8812 Pnpme 714-051-5007
SHIMANO EUROPA
Industreweg 24 NL:8071 CT Nunspeet. Holland Phona 31-34 12-722722
SHIMANO INC.
3-77 Oumalsucho, Sakai Osaka, Japan Phone 0722-23-3243
© Feb, 1995 by Shimano Inc, PIT. 32K. Printed in Japan
">
