Quick Start Guide
TMD2725 EVM
TMD2725 ALS and Proximity Sensor Evaluation Module
Version 1.0
3
4
1
2
5
Contents
Out of the Box ...................................................................................................................... 3
Software Installation ............................................................................................................. 3
Connect Hardware ............................................................................................................... 3
Start the Application ............................................................................................................. 3
Contact and Support ............................................................................................................ 5 page 2/5
1 Out of the Box
Each TMD2725 Evaluation Kit comes with the following components:
•
Controller board v2.2
•
TMD2725 Daughterboard
•
USB Cable with A connector and mini B connector
•
Flash Drive with Application Software and Documents
Figure 1 TMD2725 EVM Kit
2 Software Installation
Most PCs should have one or more Universal Serial Bus (USB) ports. Install the ams flash drive into an unused USB port. Double-click the Setup.exe file on the flash drive, or click Start -> Run and type E:setup.exe and press Enter. IMPORTANT: Use the appropriate drive letter in the above command to install the software. Flash Drive will commonly be assigned the next available drive letter for example C: hard drive D: CD-ROM E: flash drive
The Setup Wizard will open and guide you through the installation of the TMD2725 host software,
(Figures 2 through 8). To re-install, run the setup.exe program again. To remove the software from your computer (Figure 9), select ams -> TMD2725 EVM -> Uninstall TMD2725 EVM or use the
Windows Control Panel.
3 Connect Hardware
Plug the TMD2725 Daughterboard into the Controller board. (Figure 1) Always use ESD procedures when handling the EVM.
Using the enclosed USB cable, plug the mini-B connector into the EVM module. Using the other end of the cable, plug the USB A-connector into a USB port on the computer.
4 Start the Application
To start the application select ams ->TMD2725 EVM->TMD2725 EVM on the All Programs menu.
page 3/5
Figure 2 Welcome Screen Figure 5 Select Start Menu Folder
Figure 3 Liability Disclaimer Figure 6 Installation in Progress
Figure 4 Select Installation Folder Figure 7 Information Screen page 4/5
Figure 9 Remove Installation
Figure 8 Installation Completed Successfully
5 Contact and Support
For detail in using the TMD2725 EVM please refer to the User’s Guide included in the documents.
If any technical difficulties are encountered, use the Tech Support page at www.ams.com/Support to submit a technical support request anytime or call (469) 298-4200 (main) M-F 8AM-5PM CST
You may also use www.ams.com
to find worldwide local representatives in your area. page 5/5
