SEADP1RGB
1.5” MARINE-GRADE RGB
LED DRAIN PLUG REPLACEMENT
IMPORTANT NOTES!
Lights are for underwater use only.
Do not operate above water for over 5 minutes.
12V / DC operation only.
Supplied fuse must be used on Positive lead.
INSTALLATION
1.
Remove existing drain plug.
2.
Feed the SEADP1 power wire through the drain opening and screw in the light assembly. Hand tighten firmly.
3.
On the inside of the boat, leave enough slack in the power cable so the drain plug can be removed. Secure and route power cable to RGB control module.
4.
Connect wiring directly to a 12V source or use a switch. Supplied fuse must be used on positive lead.
ON
Positive +
SWITCH
12V+
87
86 87a
30
85
Negative -
IR
RECEIVER
5.
When mounting the RGB control module, the IR Receiver must be visible for the remote control to function.
SEADP1RGB SPECIFICATIONS
Housing Material Titanic Aluminum Alloy
Light Source
LED Power
Beam Angle
Working Temperature
IP Rating
Certification
Dimensions
Weight
RGB LED x 9
27W
180
-4° - 104° (F)
-20° - 40 (C)
IP68
CE, RoHS
ATC(ATE20081436)
1.77 x 1.77 x 2.44in
45 x 45 x 62mm
8.8oz / 250g
LIMITED WARRANTY:
Stinger warrants this product to be free of defects in materials and workmanship for a period of one (1) years from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized Stinger dealer in the United
States of America only. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction,
Stinger will (at its discretion), repair or replace the defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse, abuse, product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not covered under warranty.
INTERNATIONAL WARRANTIES:
Products purchased outside the United States of America are covered only by that country’s Authorized Stinger reseller and not by Stinger. Consumers needing service or warranty information for these products must contact that country’s reseller for information.
Stinger is a Power Brand of AAMP Global
15500 Lightwave, Clearwater, Florida 33760
P: 888-228-5560 [email protected]
www.stingerelectronics.com
© 2019 Stinger
