advertisement
Using the LXE
Dual-Ear Wireframe
Behind-the-Neck Headset
Part No. HX3601HEADSET
Microphone boom with windscreen
Earpads with replaceable pads
1 Adjusting to fit you
Adjustable strap
Cable with quick-disconnect connector
Clothing clip
2 Positioning microphone
2A 2B 2C
R
CAREFULLY bend headband to fit you
Side of microphone marked TALK must face lips
TALK
In front of mouth
One fingerwidth from lips
3 Connecting to client unit 4 Replacing earpads and strap
If strap gets worn, pull it off and replace it with a new one
Copyright © 2010 LXE, Inc. All Rights Reserved.
LXE is a registered trademark of LXE, Inc.
If earpiece pad gets worn, pull it off and replace it with a new one
163773-0001 Rev. A April 2010
5 Wearing audio cable
UNDER CLOTHING
(recommended)
OR OVER CLOTHING
(with cable in back)
Clip to clothing
Leave loop so head can turn
!
Clip headset cable to clothing
Leave loop so head can turn
Clip lower audio cable to clothing
Wear cable inside clothing
Wear cable across back
Attach cables securely to clothing so they let you work without restriction and cannot get tangled in something.
6 Caring for the headset
Always use windscreen
When disconnecting, pull the connectors apart
Carry headset by headband, not boom
7 In freezer environments
Do not snap them
Every four hours, or when windscreen gets moist or frozen, replace windscreen
1
!
Do not wear cable in front of body
Do not twist microphone too much
Do not bend boom too much
If the microphone stops working, it might be too wet. Try removing the windscreen, shaking moisture out of the microphone, and replacing the windscreen with a dry one
1
4 hrs
2
2
OR
3
OR
Do not squeeze wet windscreen while on boom
advertisement