Ignis 300 192 96 Hood Program Chart
Ignis 300 192 96 is a freestanding dishwasher with a 13-place setting capacity, ideal for large households. It features 6 wash programs, including an intensive cycle for heavily soiled dishes and a delicate cycle for glassware. The adjustable upper basket allows you to accommodate bulky items and the foldable tines on the lower basket provide flexibility for loading large pots and pans. The digital display shows the remaining time and the salt and rinse aid level indicators help you keep track of maintenance needs.
Reklam
Reklam
HOO 902
CZ
POPIS INSTALACE
Minimální vzdálenost od sporáků:
43 cm (elektrické sporáky), 65 cm (sporáky na plyn, naftu nebo uhlí).
Při montáži sledujte číslování (1 Ö 2 Ö 3 Ö .....).
Spotřebič připojte k elektrické síti až po úplném dokončení instalace.
SK INŠTALAČNÁ SCHÉMA
Minimálna vzdialenost' od sporáka:
43 cm (elektrické sporáky), 65 cm (plynové sporáky, sporáky na naftu alebo uhlie).
Pri montáži postupujte podľa číslic ( 1 Ö 2 Ö 3 Ö .....
).
Spotrebič nezapájajte do siete, kým nie je inštalácia úplne ukončená.
PL KARTA INSTALACYJNA
Minimalna odległość od palników:
43 cm (od palników elektrycznych), 65 cm (od palników gazowych, olejowych lub węglowych).
Podczas montażu należy przestrzegać kolejność numeracji ( 1 Ö 2 Ö 3 Ö .....
).
Nie podłączać urządzenia do zasilania zanim nie zostanie zakończony całkowicie jego montaż.
H ÜZEMBE HELYEZÉSI ÚTMUTATÓ
A tűzhelytől való minimális távolság:
43 cm (elektromos tűzhely), 65 cm (gáz-, olaj- vagy széntüzelésű tűzhely).
A felszereléshez kövesse a számozást ( 1 Ö 2 Ö 3 Ö .....
).
Ne helyezze feszültség alá a készüléket addig, amíg nem történt meg maradéktalanul az
üzembe helyezés.
RUS
СХЕМА УСТАНОВКИ
Минимальное расстояние от конфорок:
43 см (электрические конфорки), 65 см (газовые, керосиновые или угольные).
Последовательность действий при монтаже должна соответствовать нумерации ( 1 Ö 2 Ö 3 Ö .....
).
Не подключайте прибор к сети до тех пор, пока установка не будет полностью закончена.
BG КАРТА ЗА ИНСТАЛИРАНЕ
Минимално разстояние от печки:
43 см (електрически печки), 65 см (печки с газ, нафта или въглища).
За монтаж следвайте номерацията ( 1 Ö 2 Ö 3 Ö .....
).
Не включвайте уреда към мрежата, докато инсталирането не е завършено докрай.
RO FIȘA PENTRU INSTALARE
Distanţa minimă de la focuri:
43cm (arzătoare electrice), 65cm (arzătoare pe bază de gaze, motorină sau cărbune).
Pentru montaj urmaţi numerotarea ( 1 Ö 2 Ö 3 Ö .....
).
Nu branșaţi aparatul la curent până când nu terminaţi definitiv operaţia de instalare.
GB INSTALLATION SHEET
Minimum height above cooker:
43 cm (electric cookers), 65 cm (gas, gas oil or coal cookers).
To install follow the numbers (1 Ö 2 Ö 3 Ö .....).
Do not connect the appliance to the electrical power supply until installation is completed.
5019 100 75133
HOO 902
FFF
5
Ø
135mm
6 10x10mm
1
20mm
2
16mm
8
4
3
7
15
11
9
11 11
13
12
13
12
14
5019 100 75133
10
HOO 902
4
PRODUCT DESCRIPTION SHEET
CONTROL PANEL
A. Speed selector switch.
B. Light switch.
1
O 1 2 3 4
A B
O I large amount of steam and fumes medium amount of steam and fumes
2
3
1. Control panel
2. Grease filters (behind the extractor grille)
3. Lighting unit
4. Pull-out steam deflector
Removing and renewing or washing the grease filter Fig. 1-2:
1. Unplug the appliance or disconnect the mains power supply.
2. Pull out the steam deflector.
3. Remove the extractor grilles (Fig. 1).
4. Remove the device securing the grease filter
(Fig. 2).
5. Remove the dirty grease filter.
6. After the grease filter has been renewed or cleaned (depending on model), remount in reverse order, making sure the entire extraction surface is covered.
Fitting or renewing the carbon filter -
Fig. 3:
1. Unplug the appliance or disconnect the mains power supply.
2. Pull out the steam deflector.
3. Remove the extractor grilles.
4. If the carbon filter is already fitted and needs renewing, press the release buttons (b) and pull the filter out downwards.
5. If the filters are not fitted.
a. Locate the carbon filter under the top clips.
b. Secure in place with the bottom clips.
6. Refit the extractor grille.
Replacing bulbs
1. Unplug the appliance or disconnect the mains power supply.
2. Pull out the steam deflector.
3. Open the back extractor grille.
4. Remove the burnt-out bulb.
Replace using 40W max (E14) bulbs only.
5. Refit the extractor grille.
small amount of steam and fumes
Fig.1
Fig.2
Fig.3
a a
5019 100 75133
CZ SK PL H
RUS
BG RO
GB
İndir
Reklam