13
13a
14
15
4
5
6
7
1
2
3
9
10
11
8
12 on - off
1a
Refrigerator Compartment
1.
Fan*
1a . on/off fan button
1b.
cover of fan
2. Shelves / Shelf area *
3.
Thermostat / light unit
4.
Rating plate with commercial name
5.
Fruits and vegetables crisper
6.
Crisper divider *
7.
Doors reversibility kit
8.
Door trays
9.
Bottle holder *
10.
Water tank
11.
Egg tray *
12.
Door seals
Freezer Compartment
12.
Door seals
13.
Storage zones for frozen food items
(basket or flap)
13a. ECO GREEN basket for freezing fresh food or to store frozen food (only in models provided with
ECO GREEN function)
14. Bottom basket for freezing fresh food or to store frozen food
15. Ice tray*
Anti-bacterial protection:
- Antibacterial filter* in the fan (1)
- Antibacterial additives* in the material of Crisper (5)
- Door seals are made of material able to inhibit bacterial growth (12)
* Available on selected models
Notes:
- All shelves and door trays are removable.
- The internal temperatures of the appliance may be affected by the ambient temperature, frequency of door opening, as well as location of the appliance.
Temperature setting should take into consideration these factors.
- The appliance accessories are not dishwasher safe.
- After inserting food, ensure that the freezer compartment door closes properly.
PRODUCT SHEET
1b
EN
HOW TO INCREASE FREEZER STORAGE
CAPACITY
You can increase storage capacity in the freezer compartment by:
- removing the baskets and the flap to allow the storage of big products.
- placing the food products directly on the freezer shelves.
- removing the lower basket, the shelf (additional inside product) has to be placed in freezer compartment. The space below the shelf is 2 stars
(< -12 °C) and it is for frozen foodstuffs with short storage time.
- the bottom basket is specific compartment for freezing large food. After inserting food, ensure that the freezer compartment door closes properly.
HOW TO START THE APPLIANCE
After plugging the appliance to the mains, it starts the operation automatically.
After starting the appliance, wait at least 4-6 hours before placing food into the appliance.
Note:
- If food is placed in the refrigerator before the appliance has cooled completely, it may deteriorate.
FAN
The Fan improves temperature distribution inside the refrigerator compartment, allowing better preservation of stored food.
By default, the fan is switched on.
It is advisable to keep the fan switched on when the ambient air temperature is above 27 ÷ 28°C or if you notice drops of water on the glass shelves or in sever humidity conditions.
Please note that when the fan is switched on it will not continuously work.
The fan will start/stop working depending on the temperature and/or humidity level inside the fridge. It is therefore absolutely normal if the fan does not move even if the fan is switched on. The fan automatically stops working when the fridge door is open.
Note: Do not obstruct the air intake area with food items.
To guarantee the right performance at lower ambient temperature (colder than 18°C) and to minimize
Energy Consumption, turn off the fan.
To turn off the fan press the button of fan (1a).
ANTIBACTERIAL FILTER
(available on selected models)
If the appliance has the Fan it can be equipped with the antibacterial filter.
Remove it from the box placed in the crisper drawer
(5) and insert into the cover of fan (1b).
The replacement procedure is attached with the filter.
GB PL NL FR DE BG CZ DK FI GR HU IT NO PT RO RU SK ES SE UA
PRODUCT SHEET
EN
ECO GREEN FUNCTION (available on selected models)
This function gives best food preservation performance with the smallest energy consumption if there is lower amount of food to be preserved in the appliance.
The best food preservation conditions when
ECO GREEN function is activated are in the
ECO GREEN compartments:
- 2 “eco green” areas in the fridge (indicated by green stickers)
- 1 “eco green” basket in freezer compartment
To select the function turn the ECO GREEN symbol on the knob of the regulator.
FRIDGE/FREEZER
COMPARTMENT
CONTROLS
A.
Thermostat knob
B. Light button
C. Thermostat setting indicator
D. Light bulb
The thermostat adjusts temperature in both compartments.
Thermostat set to 1/MIN: low cooling intensity
Thermostat set between 1/MIN and 7/MAX : cooling intensity can be adjusted according to the preferences.
Thermostat set to 7/MAX: maximum refrigeration intensity.
For the best food conservation 3-5/ MED position is recommended.
Thermostat set to • : cooling and lighting off.
Thermostat set to ECO GREEN : ECO function active.
REPLACING THE LIGHT BULB
Before replacing the bulb, remove the power plug from the mains socket.
To remove the light bulb turn anticlockwise as shown in figure.
Check the bulb. If necessary unscrew the broken bulb and replace it with a traditional bulb (with the same characteristics of the previous one) or a LED bulb of the same type available only at our After-sales Service
Centers or authorized dealers.
FREEZING FRESH FOOD
Place the fresh food to be frozen into the bottom basket.
Avoid direct contact with already frozen food.
DEFROSTING THE REFRIGERATOR
COMPARTMENT
Refrigerator compartment defrosting is completely automatic.
Droplets of water on the rear wall inside the refrigerator compartment indicate that the automatic defrost phase is in progress. The defrost water is automatically run into a drain hole and collected in a container, where it evaporates.
DEFROSTING THE FREEZER
COMPARTMENT
The freezer should be defrosted once or twice a year or when excessive frost is present (3 mm thickness).
The formation of frost is normal.
The amount and rate at which frost accumulates depends on room conditions and how often the door is open.
To defrost the unit, switch off the whole appliance and remove all food products.
Leave the freezer door open to allow the frost to melt.
Pull out the defrost water drain and place a container under the drain (see figure).
When the operation is completed, put back the defrost water drain.
Clean the inside of the freezer. Rinse and dry thoroughly. Switch on the appliance and store the food inside.
CLEANING
Important: Before carrying out any cleaning or maintenance operation, unplug the appliance or disconnect it from the power supply.
Regularly clean the appliance using a cloth and a solution of warm water, with some soft detergent suitable for cleaning the inside of the refrigerator compartment.
Do not use abrasive detergents or tools.
To ensure continuous and correct flow of defrost water, regularly clean the inside of the draining hole on the back of the refrigerator near the fruit and vegetable drawer, using the tool provided.
GB PL NL FR DE BG CZ DK FI GR HU IT NO PT RO RU SK ES SE UA
PRODUCT SHEET
EN
UTILISATION AND MAINTENANCE OF THE WATER DISPENSER AND FILTER
Water dispenser
First use
The first time you use the water dispenser or after a long period left not used wash the tank and the filter with water.
The water dispenser provides fresh, filtered water, without the need of opening the refrigerator door. This will reduce the number of times the door is opened, thus also reducing energy consumption of the product.
Fitting and replacing the active carbon filter
The water filter should be removed from the foil bag (found in the crisper drawer (item 5). Follow the instructions provided with the filter.
Important: If the filter is left dry for an extended period of time, its performance may be reduced. Immerse the filter in water for a few seconds to reinstate optimum performance.
To fill the tank, rotate the cap in the direction of the arrow
Water tank (fig. 1)
The water tank is made of antibacterial material. This prevents and reduces the proliferation of bacteria. An internal container, with an active carbon filtered ensures water filtration.
To fill the tank: rotate the water inlet towards you and fill with water, using a jug or other suitable container. Once the tank is full, close the water inlet by moving it back to its original position.
Always use drinking water only: any other liquid may impair product performance.
Tank
Fig.1
Activation device
Stop
Water drip tray
Fig.2
Obtaining filtered water (fig. 2)
After filling the tank, the water may not be immediately available. This is because the filtering process may require a few minutes (depending on the amount of water in the tank).
To dispense water: with the refrigerator door closed, press the water dispenser tab with the glass. If for safety reason water delivery must be prevented, simply press the stop at the back of the tab. To release water delivery, move the stop back to its original position. It is recommended to drink the supplied water from the dispenser in 6 hours.
Cleaning the water tank (fig. 3-4-5-6-7-8-9)
Periodically clean the water tank with running water. Twice a year it is recommended to keep healthy the unit using specific products based on diluted chlorine that not modify the material properties and rinse with current water.
To clean the tank, proceed as follows:
- (fig. 3) release and remove the upper door tray
Fig.3
- (fig. 4) release and remove the water tank by lifting it and pulling towards you. Place the tank on a flat surface, remove and wash the top cover.
Note: the tank must be refitted in its position as soon as possible, to prevent the refrigerator from overheating.
Fig.4
GB PL NL FR DE BG CZ DK FI GR HU IT NO PT RO RU SK ES SE UA
PRODUCT SHEET
EN
- (fig. 5a -5b) remove the internal container and the filter, and wash them separately.
When washing the filter, only use clean water (no detergent or sharp tools). To clean the disk filter, first remove it from the container.
Fig.5
- (fig. 6) for a more thorough cleaning, remove the valve cap (the fitting connecting the tank to the refrigerator) by rotating it anticlockwise. Clean the cap. Important: do not pull on the valve body (fig. 7).
Fig.6 Fig.7
- (fig. 8) replace the valve cap by rotating clockwise.
Fig.8
- (fig. 9) fit the tank back in place by placing it between the lateral guides of the door and pushing it in position, ensuring that the valve is back in its original seat. Check that the there are no gaps between the rubber seal of the tank and the door.
Fig.9
Water Filter Duration
To ensure optimum performance you should change the water filter according with the following table:
Water consumption
(average)
3,0 l/day
4,5 l/day
6,0 l/day
Filter duration
4 months
3 months
2 months
Filter replacement is not covered by product warranty. To order more water filter cartridges, please contact your after-sales service.
GB PL NL FR DE BG CZ DK FI GR HU IT NO PT RO RU SK ES SE UA
