PRODUCT SHEET
GB
1.
Light
2.
Shelves / Shelf area
2a. Bottle holder (depending on model)
3.
Crisper drawer
3a. Moisture control
4.
Door trays
5.
Removable bottle holder
6.
Rating plate (at the side of the cripser drawer)
7.
Fan
7a. Fan intake area
8.
Crisper drawer divider
9.
Divider
B.
Low Temperature Compartment
C.
10.
Rack for ice cube trays and/or ice packs
(depending on model)
11.
Upper basket (area for freezing)
12.
Baskets for storing frozen food
13.
Freezer compartment door
14.
Freezer compartment door trays
Control panel
The fan gives more even temperature distribution inside the refrigerator compartment, thus allowing better conservation of stored food.
The fan can be switched on by pressing the specific button (if provided, depending on the model).
Important: the fan is electrically powered.
An electronic device switches the fan on when necessary
DO NOT obstruct the fan intake area (7a) with food.
Note: The number of shelves and shape of accessories may vary, depending on the model.
All shelves, door trays and racks are removable.
Important: refrigerator/freezer accessories must not be washed in a dishwasher.
D GB F NL E P I GR S N DK FIN
The fridge-freezer is switched on by means of the thermostat located on the frame inside the refrigerator compartment. The thermostat also serves to adjust the temperature in both the refrigerator and freezer compartments.
Control panel elements
Thermostat set to 0/Off:
Thermostat set to 1-min:
Thermostat set to 7-max:
1. Thermostat knob (depending on the model) no refrigeration.
minimum refrigeration.
maximum refrigeration.
Recommended thermostat setting: 3-4/Med position.
The fridge-freezer can operate at ambient temperatures between +10°C and +38°C.
Note: the ambient air temperature, the frequency of door opening and the position of the appliance can affect the internal temperatures of the appliance. These factors must be taken into account when setting the thermostat.
Light - replacing the bulb
Always disconnect the appliance from the power supply before replacing the light bulb. Proceed as follows:
1 - Hold the diffuser as shown and squeeze it slightly
2 - Slide it towards the rear of the appliance
3 - The inside light is not working:
• Disconnect the appliance from the mains power supply.
Depending on the model
• Remove the bulb cover.
• Unscrew or remove the bulb.
• Check the bulb and if necessary replace it.
• Some models are equipped with a special bulb, which does not unscrew. Pull towards the inside of the appliance.
This bulb is available only from our After-sales Service. Replace using maximum 15W bulb.
5019 637 33110
D GB F NL E P I GR I S N DK FIN
