Below you will find brief information for HOO 504, HOO 505, HOO 545. This document provides essential details for the correct installation of your cooker hood, including minimum distance requirements above different hob types (electric, gas). It also guides you through the functions of the control panel for light and speed selection, and provides clear instructions for maintaining your appliance by explaining how to remove, clean, or replace grease and carbon filters, as well as how to replace the lighting unit bulbs, ensuring optimal performance and longevity for your kitchen.
Advertisement
Advertisement
Advertisement
Adjustable extraction speeds for varying steam and fume levels
Integrated lighting unit for illuminating the cooking surface
Removable and cleanable grease filters for easy maintenance
Option for carbon filters to purify air in recirculation mode
Telescopic flue for flexible installation
Specific minimum installation distances for electric and gas cookers
For electric cookers, the minimum distance is 65 cm. For gas, gas oil, or coal cookers, the minimum distance is 75 cm.
First, unplug the appliance or switch off the mains power supply. Then, push the handles backwards and downwards. After cleaning or substituting, remount in reverse order, ensuring the entire extraction surface is covered.
Unplug the appliance or switch off the mains power supply. Remove the grease filters, then remove the lighting unit from its clips. Remove the burnt-out bulb and replace it with a 40W max (E14) bulb. Finally, remount the lighting unit.
Unplug the appliance and remove the grease filters. If replacing existing filters, turn the central handle anticlockwise to release them. If installing, fit one filter on each side covering the motor protection grilles and turn the central handle clockwise. Then refit the grease filters.
The control panel features a light switch (A) and a speed selector (B). The speed selector allows you to choose between settings for small (1), medium (2), and large (3) amounts of steam and fumes.
How should the grease filters be replaced or cleaned?
First, unplug the device or cut the main power. Push the handles toward the back, then down. After replacing or cleaning the filter, reassemble it in the reverse order, ensuring that the entire extraction surface is covered.
How should the carbon filters be replaced?
First, unplug the device or cut the main power. Remove the grease filters. If the old carbon filters are mounted, turn the central handle counter-clockwise until the filters release. To install new filters, place one on each side covering the two motor protection grids and turn the central handle clockwise. Finally, replace the grease filters.