HOO 523
GB
INSTALLATION SHEET
Minimum height above cooker: 65 cm (electric cookers), 75 cm (gas, gas oil or coal cookers)
ELECTRICAL CONNECTION (ONLY FOR UK)
WARNING: THIS APPLIANCE MUST NOT BE EARTHED
THIS APPLIANCE IS DOUBLE INSULATED AND MUST NOT BE EARTHED.
The mains lead of this appliance is fitted with a BS 1363 13 amp fused plug.
To change a fuse in this type of plug use an A.S.T.A. approved fuse to BS1362 type.
1. Remove the fuseholder and fuse.
2. Fit replacement 13A fuse into fuseholder.
3. Refit both into plug.
IMPORTANT: The fuseholder must be refitted when changing a fuse and if the fuseholder is lost the plug must not be used until a correct replacement is fitted.
Correct replacements are identified by the colour insert or the colour embossed in words on the base of the plug.
Replacement fuseholders are available from your local Electricity Company Shop.
HOW TO CONNECT AN ALTERNATIVE PLUG
If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere.
A suitable alternative plug of at least 13 Amp rating e.g. 15 Amp round pin to BS 546 should then be fitted to the cable.
The wires in this mains lead are coloured in accordance with the following code:-
BLUE – “NEUTRAL” - “N”
BROWN – “LIVE” - “L”
The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black.
The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured red.
5019 100 75096
HOO 523
Decorative panel
5019 100 75096
HOO 523
16
18
9
Ø6mm
C 10
Ø6mm
17
Ø8mm
15 15
13
14
17
Ø8mm
23A
17
A F
23F
17
11
Ø6mm
12 B
Ø6mm
16
19 19
24
25
180°
21
20
24
4
26
25
5019 100 75096
29
28
28
22
29
27
HOO 523
4
PRODUCT DESCRIPTION SHEET
2
CONTROL PANEL
A. Light switch.
B. Speed selector.
medium amount of steam and fumes small amount of steam and fumes large amount of steam and fumes
3
1
3
1. Control panel.
2. Grease filter (inside the extractor grille).
3. Lighting unit.
4. Pull-out Steam deflector (extractable).
REMOVING AND SUBSTITUTING OR
CLEANING THE GREASE FILTER
1. Unplug the appliance or switch off the mains power supply.
2. Pull out the steam deflector.
3. Open the extractor grille.
4. Remove the grease filter fixing device.
5. Remove the dirty grease filter.
6. After substituting or cleaning the grease filter
(depending on model) remount in reverse order, making sure the entire extraction surface is covered.
MOUNTING OR REPLACING THE
CARBON FILTER
1. Unplug the appliance or switch off the mains power supply.
2. Pull out the steam deflector.
3. Open the extractor grille.
4. If the carbon filter is mounted and needs substituting, press the buttons (d) on the filter and fit a new filter.
5. If the filter is not mounted:
c. Fit the carbon filter into the upper clips.
d. Fix securely using the lower clips.
6. Remount the extractor grille.
REPLACING BULBS
1. Unplug the appliance or switch off the mains power supply.
2. Pull out the steam deflector.
3. Open the extractor grille.
4. Remove the burnt-out bulb.
Use 40W max (E14) bulbs only.
5. Remount the extractor grille.
GB
5019 100 75096 b b
O 1 2 3
O I d c a c
B
O 1 2 3
O I
A d c b b
