advertisement
L-12/L-20/L-20R audio driver version 2 supplementary manual
September 2020
Starting with L-12/L-20/L-20R driver version 2, post master fader signals can be set as channels 1/2 sent to the computer.
Post master fader signals can now be used with streaming and audio calling software that has input channels fixed to channels 1/2 sent to the computer.
This setting can be changed from the driver control panel. Setting procedures for Windows and Mac are explained below. L-12 screens are used in these explanations, but operations are the same when using an L-20 or L-20R.
Windows
1.
Open the Control Panel. Then, from the Hardware and Sound category, open the ZOOM L-12
Control Panel or the ZOOM L-20 Control Panel.
2.
Open the Channel tab.
1
3.
Select the audio interface input channel setting.
• Normal setting
L-12
Input 1
Input 2
Audio I/F Input Ch
Ch 1
Ch 2
2-in Application
Input L
Input R
Master L
Master R
Ch 13
Ch 14
• Setting with post master fader signals input on channels 1/2
L-12 Audio I/F Input Ch 2-in Application
Master L
Master R
Input 1
Input 2
Ch 1
Ch 2
Ch 3
Ch 4
Input L
Input R
NOTE
This setting is saved on the computer.
2
Mac
1.
Open the System Preferences, and open the ZOOM L-12 Driver or the ZOOM L-20 Driver.
2.
Select the audio interface input channel setting.
• Normal setting
L-12
Input 1
Input 2
Audio I/F Input Ch
Ch 1
Ch 2
2-in Application
Input L
Input R
Master L
Master R
Ch 13
Ch 14
• Setting with post master fader signals input on channels 1/2
L-12 Audio I/F Input Ch 2-in Application
Master L
Master R
Ch 1
Ch 2
Input L
Input R
Input 1
Input 2
Ch 3
Ch 4
NOTE
This setting is saved on the computer.
3
© 2020 ZOOM CORPORATION
Copying or reprinting this manual in part or in whole without permission is prohibited.
◎ Windows® is a trademark and registered trademark of Microsoft® Corporation.
◎ Mac is a trademark or registered trademark of Apple Inc.
ZOOM CORPORATION
4-4-3 Kanda-surugadai, Chiyoda-ku, Tokyo 101-0062 Japan zoomcorp.com
4
Z2I-4129-02
advertisement
Related manuals
advertisement