Steelcase Turnstone Skeleton Bone Wire Manager Assembly Instructions

®

Package should contain the following items:

(2) black, plastic clips

1 has a slotted groove 1 does not

(2) screws and (1) washer

1 flat head #6 1 pan head #6

(1) counterweight

1 lock washer

(1) "vertebrae" wire manager

© 2001 Steelcase Inc.

Grand Rapids, MI 49501 U.S.A.

Printed in U.S.A.

Skeleton Bone Wire Manager

Page 1 of 2

TS5YWM Rev C

®

1.

Mount the vertebrae wire manager using either the slotted or non-slotted plastic clip.

(Use flat head #6 for non-slotted clip and pan head #6 & lock washer for slotted clip).

2.

Locate one side of the vertebrae in the clip and snap into place (fig 1).

Vertical Drop

Fig. 1

FLAT HEAD

SCREW

3.

Locate one side of the vertebrae in the clip and snap into place (fig 2).

LOCK

WASHER

PAN HEAD

SCREW

4.

Slide the vertebrae wire manager into the slot on the top of the couterweight. This end sits on the floor as shown (fig 3).

Horizontal Wire

Management

Fig. 2

Fig. 3

Page 2 of 2

TS5YWM Rev C