advertisement
▼
Scroll to page 2
of 4
Г ‘J an” a LEN , = Е Es Fi“ + A A ; TT AAA РЕ AS Te 9 USERS MANUAL + = a > - Е и РИ ; МИ! d po EE u et 0 a ee Е e Dir amt lu rl TELEPHONE | АТОС 05751185 www.planetaudiousa.com ue Plan et ¡AV СЛ O TECHNICAL SUPPORT wesacblanetaudiousa.comy technical Support Universal Headrest with Pre-Installed 7” (178mm) Widescreen TFT Video Monitor PHAGES 511 al sagas hcrbors sant la change mitad orice E 20159 Plone ira «Зы Downloaded from www.Manualslib.com manuals search engine e A . L Specifications Descriptions 1 Screen Size T° (178mm) TFT-LED Warni ng | Resolution 800 x 480 Read this manual before using this product. A/V Input x 2 RCA Audio & Video Composite Input № This product is composed of precision components and A eure ian a . Е г sadphone 2. z (At; should not be dissembled service must be performed FM Tranemitter 87.7/88.1/86.5/68 8/107 4/107 8 MHz by a factory authorized technician. Post Diameter 10mm Fixed Protect the product from moisture and shock, Post Dia. Adapters 12112.5/12.7/13.8 mm he A Post Distance 4.3-7.5 in (110-190 mm) с Pillow Covers Black, Grey, Tan " Power Input ÿ-15V DC Fuse 2A (ATC Type) AN specifications subject to change АКАР notion. Product installed How to use the Headrest monitor Thank you for choosing this monitor for your mobile entertainment system. To ensure longterm trouble-free service of the product, please read this Manual carefully before using the monitor. Downloaded from www.Manualslib.com manuals search engine Connection Diagram Connect the wires as indicated: a, Red: Connect to a switched(+) 12 volt source (AGC), Use a lead that has(+) 12V when the ignition on or in the ACC position so the monitors turns off when the key is in the off position. Wiring the monitors “hot” could cause your battery to run down when the engine is pol running. b. Black: Connecttoa good chassis ground. c. Reversing the polarity of the red and black leads will damage the monitor. d. Connect the video input connector to the video oulpul from the source unli o. Test the syolem. FT Installation Universal Headrest with Pre-installed Monitor Owner's Manual Congratulation on your purchase of this headrest monitor syetem. The productis designed and built to deliver excellent video quality and long lasting high performance, For best results please consult a professional mobile eletronics installer for application advice or troubleshooting. Please read these instrutions thoroughly before installation. Installation Instructions 1. Remove the existing headrest from the seat. 2. Adjust the posts of the new headrest to fit the holes in the seat where the headrest will be installed. The post can be moved together or apart grasp one postin each hand, move the posts in opposing directions (like they were walking) while pushing them toward each other or away from each other. 3. Insert the cable in the proper hole. Insert the posts into the holes in the seat and carefully work the headrest into position. Make sure the cable is not pinched. 4. Run the cable down the seat and out to the location of the video source unit (such as a DVD player). Downloaded from www.Manualslib.com manuals search engine How To Control The Monitor ir | VWI Fall 5‘ | MM J AN Looe de 8 e Fl =, 41) (a) 42 44 | 9 10 (1) POWER (7) FUP Press to tura unit OM ог OFF from leftlri , @) MODE righitimprdown Lise this bulton lo awilch batween AN Source 1 and АЛ Source 2 (8) Remove switch (3) vo. Speaker Volume down Я Adapter Post (4) MENU Open the susiem menu to access setting. an REMOTE IR SENSOR 5) VOL+ 43 IR Volume up #3 AN E Input 6) 16:914:3 ® 18-9 or 4:3 is a mode to switch the image 4d) HEADPHONE JACK of screen. Downloaded from www.Manualslib.com manuals search engine Change the direction of mage of screen Installation Adapter Posts u Since the spacing of the mounting holes can vary on different veicles we supply two Adapter Posts(12 diameter). Use these Adapter Posts when the headrest mounting holes in your seat are too large for the Adapter a _ Posts of the headrest monitor. | ~~) A Em How to adjust the distance between the Adapter Posts —— see the picture on the right and you can adjustthe distance between the Adapter Posts to required space. Pull Pull Remote control © POWER Press to turn unit ОМ or OFF. display menu system. Once enacied, E this bution Is used as an ENTER button. | (4) LEFT/RIGHT BUTTONS These buttons are Used to increase or decrease parameters in the on- screen display menu system. (5) MODE SELECT 18:Bandd:3mode walboh
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project