poly-planar ME6005D 5 Channel Amplifier Owner’s Manual

 Owners Manual
ME6005D
3-CHANNEL AMPLIFIER
FEATURES
« Sealed chassis for water protection in Xtreme environments
* Ultra-efficient full range class D operation
« High and low level inputs - connects with any system
« Built in crossover for maximum flexibility
«2 or 4 or 5 channel input for easy installation
¢ Durable stainless steel 6 aluminum hardware
SPECIFICATIONS
RMS power @ 4ohms: 50W x 4 +150 x 1
RMS power @ 20hms: 75w x 4 + 300 x 1
« Bridged power at 4ohms: 150 x 2 + N/A
« Total Harmonic Distortion: < 0.6% @ 40
« Signal To Noise Ratio: 97dB
« High Pass Filter: 120Hz/80Hz/OFF
« Low Pass Filter: 80Hz/120Hz
¢ Subsonic Filter 50Hz/15Hz
* Input Range: 200mV - 10V
« Frequency response: 20Hz to 20KHz
« Dimensions: 11.4"x4"x1.75"
FUNCTIONS
LPF/SUBSON
BOHz SOHZ
la Fal
LA о 00
EN LPF/SUBSONIC X-OVER
e fixed crossover frequency settings
LPF / SUBSONIC
80Hz 50Hz
120Hz un 15Hz
EI FRONT/REAR CROSSOVER
Adjust the crossover frequency to one of 3 settings using the convenient 4-way switch
12042 5555 | вон: FLUM | ea (lalala
Е] LOW (RCA) HIGH LEVEL INPUT
Waterproof MOLEX connector allows 4 channel RCA or speaker level harness to be attached
С] FRONT/REAR/ SENSITIVITY
Independent level control for front and rear channels
Е] WATERPROOF RUBBER COVER
Rubber cover can be attached by inserting the rubber stem into mounting hole
[3] POWER/PROTECTION INDICATOR
The dual color LED light will indicate when the amp is on and if it has gone into protection mode
BLUE: Power is ON RED: Protection Mode
YELLOW: +12V BLACK: Ground BLUE: Remote In
EJ SPEAKER DUTPUT CABLE
WHITE: Front Output Left (+) GREEN: Rear Output Left (+)
WHITE/BLACK: Front Output Left( -) GREEN/BLACK: Rear Output Left (-)
GRAY: Front Output Right (+) VIOLET: Rear Output Right (+)
GRAY/BLACK: Front Output Right (-) VIOLET/BLACK: Rear Output Right ( -)
EX SENSITIVITY CONTROL
Input sensitivity level control
Ul] SUBWOOFER OUTPUT CABLE
BLUE: Speaker output + BLUE/BLACK: Speaker output -
POWER INPUT WIRING
|
Remote Turn On
| Fuse Holder
1
L = +
Chassis | Battery
Ground Near Battery
LOW LEVEL INPUT WIRING
er LD (CDs
а “> =>
Remote BassControl
SPEAKER OUTPUT WIRING
5 Channel Output
O. 0)
: wa
PRT 7
©
Blue Sub (+)
(2 ohms)
Subwoofer
Blue/White Sub [-]
Speaker Maler White LE) Speaker
(4 ohms) Po RR White/Black LE) | (4 ohms)
Speaker Green ВЕСУ Gray FR (4 Speaker
(4 ohms) En Green/Black RL (-] Gray/Black FR —— (4 ohms)
Bridged 2 Channel Output
O. ‚ ©
PWR
PRT
© ©
¿Breent+)
Violet /Black (-)
¢ White (+)
Gray/Black (-)
Speaker Speaker
(4 ohms) (4 ohms)
qe RL(+] White FL (+) _
еек RRE) И |
TROUBLESHOOTING
When troubleshooting your amp, speaker and speaker wires should be tested first.
No Output:
« Confirm all wiring is firmly connected.
Both +12V and REM terminals must have +12 Volts present and GND must be connected to chassis’ ground or to
the negative battery terminal.
« Confirm the signal source is connected and supplying an output signal. To confirm the amp is working, connect
an RCA patch cord to the line inputs of the amplifier (do not connect the other end of the patch cord). Briefly tap
the center pin of each disconnected RCA with your finger. This should produce a noise (brief static or hum) in
the speakers.
« If the amp is hot, check the speaker impedance or load. The total minimum impedance of all speakers should
not be lower than the rating of the amp.
Weak Output;
* Check gain control adjustment
* Check speaker impedance
Unwanted Noise
« Whine that increases and decreases with engine speed - confirm the Amp & Source unit are grounded properly.
* Clicking or popping noise at a rate that follows engine speed - this is often induced by the vehicles ignition system.
Confirm that the vehicle is equipped with resistor spark plugs and wires. The ignition system may need service.
« Noise can be caused by routing speaker input wires too close to the light wires and other accessory wires in the
vehicle. Re-route wires to avoid unwanted interference.
« If above steps do not improve/reduce noise, the system should be checked by a professional audio installer at a
Memphis Authorized Dealer.