SNIPER
STERILE
STAPLE SYSTEM
The Sniper Sterile Staple System is a premium, precise, and consolidated single kit composed of a dynamic compression staple, disposable deployment device, and instrumentation.
STAPLE SYSTEMS
• Fine trigger dispensing mechanism for accurate
deployment without disruption to osteotomy/
fracture site
• Low profile, high-strength, super elastic nitinol
compression staple implants designed with
dual-barbs intended to mitigate migration without
increasing difficulty of revision
• A robust, stainless steel drill guide utilizes unique
snap-off combo drill posts to allow for ease of use
in staple placement
• Simple intra-operative staple reloading
capabilities intended to minimize implant waste
• Available in 8x8x8mm and 10x10x10mm kit sizes
SNIPER STERILE STAPLE SYSTEM
Staple Size*
Wire Size
Part Number
8.0 x 8.0mm
1.6 x 1.3mm
500-08-001
*Bridge Length x Leg Length
10.0 x 10.0mm
1.6 x 1.3mm
500-10-001
SURGICAL TECHNIQUE
STEP 1: Place a bone clamp to create the necessary compression across the osteotomy of the fusion site (when applicable).
STEP 2: Place drill guide in desired position across the osteotomy or fusion site.
STEP 3: Drill the first hole in the bone using the snap-off drill post provided. Toggle the proximal shaft of the snapoff drill post to remove the drill shaft and create a post.
STEP 4: Pivot position of the drill guide if desired.
STEP 5: Drill second hole using addi- itional snap-off drill post provided.
STEP 6: Remove drill guide and post. Insert staple legs into pre-drilled holes until the distal tip of the deployment device abuts the osteotomy site.
STEP 7: Press trigger to deploy the staple.
STEP 8: Fully seat the staple.
STEP 9 (OPTIONAL): The distal section of the deployment device may be utilized as an impactor to fully seat the staple if deemed necessary by the surgeon.
Sterile Kit Contents
FDA cleared 510(k) K162354.
Trilliant products are made in the U.S.A.
T 800.495.2919 F 877.778.3864
727 North Shepherd Drive, Suite 100 I Houston, TX 77007 I U.S.A.
djoglobal.com
Copyright © 2021 by DJO, LLC
900-00-083 Rev G
Individual results may vary. DJO, LLC is a manufacturer of orthopedic implants and does not practice medicine. Only an orthopedic, or foot and ankle surgeon can determine what treatment is appropriate.
The contents of this document do not constitute medical, legal, or any other type of professional advice.
This material is intended for the sole use and benefit of the DJO, LLC sales force and physicians.
It is not to be redistributed, duplicated, or disclosed without the express written consent of DJO, LLC.
For more information on risks, warnings, and possible adverse side effects refer to the Instructions for
Use provided with the device.
STAPLE RELOADING (IF NECESSARY)
STEP 1: Insert staple legs into the appli- cable holes in the safety cap.
STEP 2: Press firmly until staple is fully seated and legs are in the parallel orientation.
STEP 3: Press trigger t to open deployment
STEP 4: Release the trigger and push barrel forward to reload the staple.
STEP 5: Remove
