Rostra 2269-1 Installation Instructions

NOTE:

I.

THE NEW UNIVERSAL CONTROL SWITCH IS DESIGNED TO BE USED ON VEHICLES

WITH AN UPPER AND LOWER SHROUD.

REMOVE SCREWS FROM SHROUD AND SNAP OPEN. INSTALLER CAN BE CREATIVE IN

LOCATING AREA FOR MouNT.NG. PICK A FAIRLY FLAT AREA. SWITCH CAN BE

MOUNTED ON UPPER OR LOWER SHROUD.

2.

3.

CONTROL SWITCH MUST BE LOCATED IN THE AREA OF DRIVER'S CONVENIENCE AND

NOT TO INTERFERE WITH WIRING AROUND STEERING COLUMN. MAKE SURE POSITION

ALLOWS FOR KNEE CLEARANCE FOR CLUTCH OPERATION AND / OR BRAKE OPERATION .

DRILL 3/8" DIAMETER HOLE IN SHROUD. INSERT WIRE HARNESS THROUGH HOLE.

INSERT THREADED END OF SWITCH THROUGH HOLE IN SHROUD. INSTALL LOCK

WASHER AND NUT. SEE FIG 1.

4.

5.

6.

7.

POSITION CONTROL SWITCH ON SHROUD FOR DRIVER'S CONVENIENCE. TIGHTEN NUT.

ROUTE WIRES ALONG STEERING COLUMN TOWARDS THE BULKHEAD. REINSTALL THE

SHROUD.

INSTALL 4 PIN CONNECTOR ONTO CONTROL SWITCH WIRES. RED TO "R", BROWN TO

"B", GREEN TO "a" AND YELLOW TO "Y".

THE CONTROL SWITCH CAN BE POSITIONED AT ANY ANGLE DESIRED. FROM FUNCTION

END OF SWITCH, PUSH RUBBER BOOT TOWARD STEERING COLUMN. (THE UNIVERSAL

JOINT SET-UP IS USED FOR ANGLE ADJUSTMENT). AFTER DESIRED ANGLE IS

DETERMINED, TIGHTEN BOTH NUTS. REPLACE RUBBER BOOT TO ORIGINAL POSITION.

SEE FIG 2.

Ros tra

Inc. 1999

Certified Q8 9000/180 9001

Made in the u .8.A.

FORM# 2269

REv-A

07/99

=-=~

=-:.=3

I :>

~

ANGLE ADJUSTMENT BOOT

---

I.

4- PIN CONNECTOR r--'l

9

UIc-

,

<:: I

SHROUD

(UPPER OR LOWER)

FIGURE 2

~I

, BOOT