Shure BRH440M BRH441M Broadcast Headset User Guide
Add to My manuals12 Pages
Shure BRH440M is a broadcast headset with a dynamic microphone and closed-back circumaural design for excellent noise isolation. Its cardioid polar pattern and frequency response are optimized for clear vocal reproduction in loud environments. The flexible boom can be worn on either side and features a flip-up mute function. The detachable cable enables connection to various devices and is easily replaceable, extending the product's lifespan.
advertisement
BRH440M BRH441M
Broadcast Headset
The Shure broadcast headesets, BRH440M and BRH441M, user guide.
Version: 2.1 (2021-E)
Shure Incorporated
Table of Contents
BRH440M BRH441M Broadcast Headset 3
2/12
Shure Incorporated
BRH440M BRH441M
Broadcast Headset
LIMITED WARRANTY
Shure Incorporated (“Shure”) hereby warrants to the original consumer purchaser only that, except as otherwise specified be low, this product will be free in normal use of any defects in materials and workmanship for a period of two (2) years from the consumer’s original date of purchase directly from Shure or from a Shureauthorized reseller.
Any rechargeable batteries contained in or packaged with this product are so warranted for a period of one (1) year from the consumer’s original date of purchase. However, rechargeable batteries are consumable and their capacity will be reduced over time based on temperature, amount of time in storage, charging cycles, and other factors; hence reduction in battery capacity does not constitute a defect in material or workmanship.
At its sole option, Shure will repair or replace the defective product and promptly return it to you. In order for this warranty to be valid, the consumer must, at the time the product is returned, provide proof of purchase in the form of the original purchase re ceipt directly from Shure or from a Shureauthorized reseller. If Shure elects to replace the defective product, then Shure re serves the right to replace the defective product with another product of the same model or a model of at least comparable quality and features in Shure’s sole determination.
If you believe this product is defective within the warranty period, carefully repack the unit, insure it and return it with proof of purchase, postage prepaid, to Shure Incorporated, Attention: Service Department, at the address below.
Outside of the United States, return the product to your dealer or Authorized Service Center. Addresses are listed on www.Shure.com or can be obtained by contacting Shure at the address listed below.
This warranty is not transferable. This warranty does not apply in cases of abuse or misuse of the product, use contrary to
Shure’s instruction, ordinary wear and tear, an act of God, negligent use, purchase from a party other than Shure or a Shure authorized reseller, unauthorized repair, or modification of the product.
ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DIS
CLAIMED TO THE EXTENT PERMITTED UNDER APPLICABLE LAWS AND, TO THE EXTENT NOT PERMITTED, ARE
HEREBY LIMITED TO THE DURATION AND TERMS OF THIS WARRANTY. SHURE ALSO HEREBY DISCLAIMS ALL
LIABILITY FOR INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or conse quential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
This warranty does not restrict the rights of the consumer mandated under applicable laws.
THIS WARRANTY SUPERSEDES ALL OTHER WARRANTIES THAT ARE ASSOCIATED OR INCLUDED WITH THIS PROD
UCT, EXCEPT THAT ANY SOFTWARE CONTAINED IN OR PACKAGED WITH THIS PRODUCT IS EXCLUDED FROM THIS
WARRANTY AND INSTEAD SHALL BE COVERED BY THE WARRANTY, IF ANY, PROVIDED IN SHURE’S END USER LI
CENSE AGREEMENT ACCOMPANYING SUCH SOFTWARE.
Service Centers
United States, Canada, Latin America, Caribbean
Shure Incorporated
Attn: Service Department
945 Chaddick Dr.
Wheeling, IL 60090-6449 U.S.A.
3/12
Shure Incorporated
Europe, Middle East, and Africa
Shure Europe GmbH
Attn: Service
Jakob-Dieffenbacher-Str. 12,
75031 Eppingen, Germany
IndonesiaService Center Resmi:
Jakarta Hotline (021) 612 6388
Medan (061) 6612550
Surabaya (031) 5032219
Jogjakarta (0274) 371710
Denpasar (0361) 766788
Makasar (0411) 324652
General Description
The BRH441M Broadcast Headset and the BRH440M Broadcast Stereo Headset are developed especially for use in broad cast and media production. Circumaural ear cups block out background noise, and the dynamic, cardioid microphone delivers natural, highly intelligible vocal reproduction. Wearable on the left or right side, the flexible boom features a flipup mute func tion that deactivates the microphone when raised vertically. A detachable cable with unterminated ends enables connection to a variety of devices, and is easily replaceable for a lifetime of use. The BRH440M features stereo monitoring, while the
BRH441M leaves one ear open to the surrounding environment.
•
•
•
•
•
•
•
•
Closed-back, circumaural design provides excellent isolation from background noise
Dynamic microphone delivers natural, highly intelligible vocal reproduction with cardioid polar pattern and frequency re sponse optimized for communication in loud environments
Ergonomic, lightweight design with adjustable, padded headband for long wearing comfort
Flexible boom microphone pivots 250 degrees for left or right side wear
Flip-up mute function deactivates the microphone when boom is raised vertically
Single-side, detachable cable with unterminated ends (stripped and tinned) enables connection to a variety of devices
User-replaceable cable, earpads, and windscreen for a long product life
Legendary Shure durability to withstand the rigors of professional use
Care and Maintenance
Clean using a soft, damp cloth.
CAUTION: Do not use cleansers that contain solvents. Keep liquid and foreign objects out of the driver openings.
4/12
Detachable Cable
Attach the cable by aligning the arrows and pressing firmly into place until locked.
Shure Incorporated
Pull on the knurled collar to disengage lock and remove cable.
Wearing the Headset
Adjust the headband for a comfortable fit.
5/12
Shure Incorporated
Position the boom so the microphone is within 13 mm (1/2 inch) of the corner of your mouth. To avoid "popping" or other breath noise, do not place directly in front of mouth.
The boom swivel allows the headset to be worn on either side of your face.
Flip-Up Mute Function
Swivel the boom vertically to the indented position at the headband to mute the microphone.
6/12
Shure Incorporated
Specifications
Net Weight
without cable
BRH440M
BRH441M
Packaged Weight
BRH440M
BRH441M
Cable
Detachable cable (sold separately)
376 g (13.26 oz.)
240 g (8.5 oz.)
0.8 kg (1.75 lbs)
0.69 kg (1.52 lbs)
Environmental Conditions
Operating Temperature
Storage Temperature
Relative Humidity
Microphone
18° to 60° C (0° to 140° F)
-29° to 74° C (-29° to 165° F)
0 to 95%
Type
Dynamic, Neodymium magnet, 12.5 mm
Polar Pattern
Cardioid
Frequency Response
50 to 15,000 Hz
Output Impedance
150 Ω
Sensitivity
at 1 kHz, open circuit voltage
66.5 dBV/Pa* (0.47 mV)
Polarity
Positive pressure on diaphragm produces positive voltage on pin 1 (red wire) with respect to pin 2 (black wire).
Headphone
Transducer Type
Dynamic, Neodymium magnet
7/12
Driver Size
40 mm
Frequency Response
20 to 18,000 Hz
Sensitivity
@ 1 kHz
101 dB SPL/mW
Impedance
@ 1 kHz
300 Ω
Maximum Input Power
1000 mW
Shure Incorporated
8/12
Shure Incorporated
Accessories
Replacement Parts
1 Pair of Replacement Earcup Pads
Windscreen
Temple Pad
BRH Broadcast Cable Accessories
The following tables describe wiring for BRH detachable cables. All BRH detachable cables contain six conductors with dis crete termination at the Shure 6-pin connector that plugs into the headset. For pre-terminated cables, conductors (and signal) are tied to common contacts at the other end of the cable where shown.
9/12
Shure Incorporated
Connector Pin Diagram
BCASCA-NXLR4 (male connector)
4-Pin XLR-M Signal
1 Mic −
2
3
4
Mic +
Mic Ground
Headphone Audio Ground
Headphone Audio 1
Headphone Audio 2 (boom side)
BCASCA-NXLR4-FEM (female connector)
4-Pin XLR-F Signal
Mic −
1
Mic Ground
2
3
Mic +
Headphone Audio Ground
4 (thru 47uF cap)
Headphone Audio 1
Headphone Audio 2 (boom side)
BCASCA-NXLR5 (male connector)
5-Pin XLR-M
1
Signal
Mic −
2
3
Mic +
Mic Ground
Headphone Audio Ground
Wire
Black
Red
Shield (uncoated)
White
Orange
Green
Wire
Black
Shield (uncoated)
Red
White
Orange
Green
Wire
Black
Red
Shield (uncoated)
White
6
4
5
1
3
6-Pin Headset Connector
2
6
4
5
3
1
6-Pin Headset Connector
2
1
3
6-Pin Headset Connector
2
6
10/12
Shure Incorporated
5-Pin XLR-M
4
5
BCASCA-NXLR3QI
Signal
Headphone Audio 2 (boom side)
Headphone Audio 1
Connector
3-Pin XLR-M
6.3 mm (1/4") TRS
Contact
1
2
3
Sleeve
Tip
Wire
Green
Orange
Signal Wire
Mic Ground
Mic +
Mic −
Headphone Audio Ground
Headphone Audio 2 (boom side)
Headphone Audio 1
Shield (uncoated)
Red
Black
White
Green
Orange Ring
BCASCA1 (unterminated)
Signal
Mic +
Mic −
Mic Ground
Headphone Audio 1
Headphone Audio 2 (boom side)
Headphone Audio Ground
Wire
Red
Black
Shield (uncoated)
Orange
Green
White
6-Pin Headset Connector
5
4
1
2
6-Pin Headset Connector
3
6
5
4
5
6
3
4
6-Pin Headset Connector
1
2
SAFETY PRECAUTIONS
The possible results of incorrect use are marked by one of the two symbols—"WARNING" and "CAUTION"—depending on the imminence of the danger and the severity of the damage.
WARNING: Ignoring these warnings may cause severe injury or death as a result of incorrect operation.
CAUTION: Ignoring these cautions may cause moderate injury or property damage as a result of incor rect operation.
11/12
Shure Incorporated
CAUTION
•
•
•
Never disassemble or modify the device, as failures may result.
Do not subject to extreme force and do not pull on the cable or failures may result.
Keep the product dry and avoid exposure to extreme temperatures and humidity.
WARNING
•
•
If water or other foreign objects enter the inside of the device, fire or electric shock may result.
Do not attempt to modify this product. Doing so could result in personal injury and/or product failure.
This device is able to produce sound volume higher than 85 dB SPL. Please check your maximum allowed continuous noise exposure level based on your na tional employment protection requirements.
WARNING
LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOL-
UME AS POSSIBLE. Over exposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss (NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.
90 dB SPL at 8 hours
95 dB SPL at 4 hours
100 dB SPL at 2 hours
105 dB SPL at 1 hour
110 dB SPL at ½ hour
115 dB SPL at 15 minutes
120 dB SPL
Avoid or damage may occur
Certifications
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Global Compliance
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Email: [email protected]
www.shure.com
12/12
advertisement
Key Features
- Closed-back, circumaural design for excellent noise isolation
- Dynamic microphone with cardioid polar pattern for clear vocal reproduction
- Ergonomic design with adjustable, padded headband for comfort
- Flexible boom microphone for left or right side wear
- Flip-up mute function for easy microphone muting
- Detachable single-sided cable for easy device connectivity
- User-replaceable cable, earpads, and windscreen for extended product life
Related manuals
Frequently Answers and Questions
What type of microphone does the BRH440M have?
Can the boom microphone be worn on either side of the head?
Does the BRH440M have a mute function?
Is the cable of the BRH440M replaceable?
advertisement
Table of contents
- 3 Service Centers
- 7 Net Weight
- 7 Packaged Weight
- 7 Cable
- 7 Environmental Conditions
- 7 Microphone
- 7 Type
- 7 Polar Pattern
- 7 Frequency Response
- 7 Output Impedance
- 7 Sensitivity
- 7 Polarity
- 7 Headphone
- 7 Transducer Type
- 8 Driver Size
- 8 Frequency Response
- 8 Sensitivity
- 8 Impedance
- 8 Maximum Input Power
- 9 Replacement Parts
- 9 BRH Broadcast Cable Accessories
- 10 BCASCA-NXLR4 (male connector)
- 10 BCASCA-NXLR4-FEM (female connector)
- 10 BCASCA-NXLR5 (male connector)
- 11 BCASCA-NXLR3QI
- 11 BCASCA1 (unterminated)
- 12 CAUTION
- 12 WARNING
- 12 WARNING