MODEL
90-PRV-175-15
Standards
NFPA 14
• Class II & III Standpipe Systems
Dimensions
A
Pressure Restricting Valve
LISTED
• Sensitive and Accurate Pressure Restriction
• Easy Adjustment and Maintenance
• UL/ ULC Listed
• FM Approved
The Cla-Val 1 ½” Model 90-PRV-175-15 features a Forged
Brass finish body with Forgeline Bonnet and Seat
Assembly. The system water pressure is controlled by adjusting the flow restriction, however, if full flow is required the restriction can be overridden.
This heavy duty design is factory tested to 300 psi (2070
KPa). It is also UL/ULC Listed and FM approved.
A brass body is standard but can be supplied with a polish chrome, cast chrome or polish brass finish.
Specifications
Cla-Val Model 90-PRV-175-15 UL/ULC Listed and FM
Approved 300 lb. (2070 kPa) pressure tested standard angle hose valve where standpipe pressure on a hose rack assembly or as a fire department outlet connection is less than 90 psi (620 kPa).
End Connection Options
• Female NPT x Male Hose (Angle)-FM
• Female NPT x Female NPT
• Groove X Male Outlet
A
Dimensions
A
End Connection Type
1 2
3-7/8”
98.4 mm
3-7/8”
98.4 mm
B
(open)
8”
203.2 mm
8”
203.2 mm
B
(closed)
C
7”
177.8 mm
2-3/4”
54.0 mm
7”
177.8 mm
2-1/8”
54.0 mm
C C
CLA-VAL
1701 Placentia Avenue • Costa Mesa CA 92627 • Phone: 949-722-4800 • E-mail: [email protected] • Website cla-val.com
Copyright Cla-Val 2021 Printed in USA Specifications subject to change without notice.
E-90-PRV-175-15 (R-03/2021)
