Tech Lighting Exo 6 Flush Mount Instructions

Installation Instructions for

Exo Flush Mount

FLUSH

G P I :

These fixtures are intended to be installed utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with a low-voltage electronic dimmer, 0-10V dimmer or TRIAC dimmer.

This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.

Use minimum 90°C supply conductors.

SAVE THESE INSTRUCTIONS!

Install the Mounting Plate

1A

MOUNTING PLATE

1B

2

1

3 3

#8-32 SCREW #8-32 SCREW

MOUNTING PLATE

FIXTURE

SCREW

ALLEN

WRENCH

920FMEXO

700FMEXO_

CONDUIT

FIXTURE HOUSING

J-BOX

1 Remove the fixture screws located on both sides of the fixture housing using the provided Allen wrench.

2

Remove the mounting plate from the fixture base.

Note: If using the optional Exo J-Box for open ceiling configurations you can discard the mounting plate, but save the fixture screws.

1

3 Secure the mounting plate to the electrical box with the two provided #8-32 screws.

4 (Optional) : If using the Exo J-Box connect the conduit or romex to any of the available knockouts.

Note: If using the optional Exo J-Box for open ceiling configurations secure the J-Box in accordance with local codes.

Mounting hardware for the Exo J-Box is not included and should be supplied by the installer .

Install the Fixture

2A

1

2 3

4

Optics and Lenses

4A

LENS

OPTIC

LED HOUSING

COVER

1

Connect the fixture to a suitable ground in accordance with local electrical codes.

2 Connect the black driver wire to the hot power line wire with a wire nut.

3 Connect the white driver wire to the neutral power line wire with a wire nut.

4 For 0-10V dimming, use the purple and gray/pink wires to connect to a compatible dimmer. Keep wires capped if not in use.

5 Place all wires and wire nut connections inside the fixture base.

6

Install the fixture housing to the mounting plate or Exo

J-Box using the fixture screws (reversal of step 1A).

Adjust the Module

3A

1

2

3

Unscrew and remove the

Remove the optic.

LED housing cover.

If installing an optional lens, rest the lens inside the housing cover.

4 Install the optic (replacement or existing) inside the LED housing cover.

5

Screw the LED housing cover back on.

WARNING: Always squeeze the two tabs when adjusting the

LED housing. Failure to do so will damage the finish.

1 Squeeze the LED housing tabs and rotate the housing to the desired position.

LED

©2022 Tech Lighting, L.L.C. All rights reserved. The Tech Lighting logo is a registered trademark of Tech Lighting.

Tech Lighting reserves the right to change specifications for product improvements without notification.

2

7400 Linder Ave., Skokie, IL 60077

T 847.410.4400 | F 847.410.4500

www.techlighting.com