Tech Lighting Dobson II 3-Light Bath Instructions

Installation Instructions for

Dobson II 3 and 4 Light Bath (Standard)

920BCDOBSII34S

700BCDBS_

1.0

B ATH C OLLECTION

GENERAL PRODUCT INFORMATION:

These fixtures are intended to be installed utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

This product may be dimmed with a low-voltage electronic dimmer.

This instruction shows a typical installation.

Install the Fixture

1A

MOUNTING

PLATE

4

6

This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

5

ALLEN SCREW

ALLEN WRENCH

5

6

7

3

4

1

2

With the provided Allen wrench, remove the Allen screws on top and bottom of the fixture base.

Remove the mounting plate from the back of the fixture.

Attach the mounting plate to the electrical box using the two provided #8-32 screws.

Connect the fixture to a suitable ground in accordance with local electrical codes.

Connect the white driver wire to the neutral power line.

Connect the black driver wire to the hot power line.

Properly place the all wires and wire nut connections into the electrical box, then mount the fixture back onto the mounting plate and reinstall Allen screws (reversal of step 1A).

1

SAVE THESE INSTRUCTIONS!

2

7400 Linder Ave, Skokie, IL 60077

847.410.4400

www.techlighting.com

© 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.

A Generation Brands Company