Tech Lighting Akova Wall Instructions
Add to My manuals2 Pages
Tech Lighting Akova Wall is a dimmable light fixture, suitable for damp locations, that can be mounted up or down. It can be connected to a low-voltage electronic dimmer and can be installed using the included mounting plate and screws. Proper installation should be carried out by a person familiar with the construction, operation, and hazards associated with the product.
advertisement
![Tech Lighting Akova Wall Instructions | Manualzz Tech Lighting Akova Wall Instructions | Manualzz](http://s1.manualzz.com/store/data/066750579_1-ab5b3f95a480c29b5df6beccb40380f0-360x466.png)
Installation Instructions for
Akova Wall
920WSAKOVA
700WSAKV_
1.0
W ALL C OLLECTION
G P I :
These fixtures are intended to be installed utilizing NEC compliant junction boxes.
This product is suitable for damp locations.
This product can be dimmed with a low-voltage electronic dimmer.
This product can be mounted up or down.
This instruction shows a typical installation.
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
Install the Fixture
1A
ALLEN
WRENCH
1
1
FIXTURE
SCREW
1B
3
MOUNTING
PLATE
3
1 1
#8-32 SCREW
1
Remove the four fixture screws from the sides of the fixture using the provided Allen wrench.
2
Remove the mounting plate from the back of the fixture.
1
3
Attach the mounting plate to the electrical box using the two provided #8-32 screws.
1C
ANCHOR
1E
11
9
11 10
ANCHOR
DRIVER
4 Verify that the mounting plate is level before continuing.
5 Line an anchor tip with the center of an anchor hole, and push the anchor into the wall up to the threads.
6 Screw the anchor in the rest of the way with a Phillipshead screwdriver.
7 Repeat for the other anchor hole.
1D
ANCHOR
WASHER
SCREW
9 Connect the mounting plate ground wire to a suitable ground according to local electrical codes.
10
Connect the white driver wire to the neutral power line wire with a wire nut.
11 Connect the black driver wire to the hot power line wire with a wire nut.
12 Properly place the driver. all wires, and wire nut connections into the electrical box.
13 Mount the fixture by sliding it back onto the mounting plate and reinstalling the fixture screws (reversal of figure 1A).
11
ANCHOR
8 Slide a #8 screw through a washer, and screw it into an anchor to secure the fixture base to the wall. Repeat for the other anchor.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.
A Generation Brands Company
2
advertisement