Tech Lighting Oko 3-Light Bath Instructions

Installation Instructions for

Oko 3 and 4 Light Bath

700BCOKO_

920BCOKO34

1.0

B ATH C OLLECTION

GENERAL PRODUCT INFORMATION:

These fixtures are intended to be installed utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

This product may be dimmed with a low-voltage electronic dimmer.

This instruction shows a typical installation.

Install the Fixture

1A

MOUNTING

PLATE

This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

FIXTURE

SCREW

ALLEN

WRENCH

7

9

#8-32

SCREW

ANCHOR

ANCHOR SCREW

AND WASHER

8

3

4

1

2

7

8

9

10

5

6

Remove the fixture screws located on the top and bottom of the fixture base with the provided Allen wrench.

Remove the mounting plate from the fixture base

Install the mounting plate to the junction box with the two #8-32 screws provided.

Verify that the mounting plate is level before continuing. Line up an anchor tip with the center of an anchor hole, and push the anchor into the wall up to the threads.

Screw the anchor in the rest of the way with a Phillips-head screwdriver. Repeat for the other anchor hole.

Slide a #8 screw through a washer, and screw it into an anchor to secure the fixture base to the wall. Repeat for the other anchor.

Connect the fixture to a suitable ground in accordance with local electrical codes.

Connect the white driver wire to the neutral power line.

Connect the black driver wire to the hot power line.

Properly place the all wires and wire nut connections into the fixture base, mount the fixture back onto the mounting plate, and reinstall the fixture screws (reversal of step 1A).

1

SAVE THESE INSTRUCTIONS!

2

7400 Linder Ave, Skokie, IL 60077

847.410.4400

www.techlighting.com

© 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.

A Generation Brands Company