advertisement
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during assembly
* This item may require periodic tightening
Parts List and Hardware List
PICTURE PIECE
A
DESCRIPTION
Headboard
QUANTITY
1X
ASSEMBLY INSTRUCTIONS APPLICABLE FOR ALL
SAFAVIEH HEADBOARDS.
THE DESIGN OF THE HEADBOARD IN THE DRAWINGS
MAY VARY FROM YOUR ACTUAL HEADBOARD, BUT
ASSEMBLY IS THE SAME ON ALL MODELS AND
SIZES.
B
H1
Metal Leg
Nut
2X
4X
H2 Washer 12X
H3 Big bolt M8 x 30mm 4X
H4 Small bolt M6 x 25mm 4X
The hardware that is needed to connect the headboard to the bed frame is included.
Please note that our headboard legs are compatible to most standard bedframes. Our headboards DO NOT include a mounting bracket*.
Example of Mounting
Bracket*
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
B
B
Unscrew 2 bolts and 2 washers
A
H3
H2
Step 1
Remove the legs (B) from the back of the headboard (A) by unscrewing the 2 big cross bolts (H3) and 2 washers (H2). The bolts and washers need to be re-used to attach the legs in the correct position in Step 2.
B
A B
Step 2
Attach the two legs (B) to the headboard (A) using 4 big cross bolts (H3) and 4 washers (H2).
The vertical slots at the lower part of the leg must be facing the outside of the bed.
Use the left slot to attach the metal leg to the left side of the metal frame on the left side. Use the right slot on the right side.
B
H1
H2
H2
H4
H4 H2
B
H2 H1
H4 H2
B
H2 H1
Step 3
The hardware needed to connect the headboard to the bed frame are 4 small bolts (H4), 8 washers (H2), and 4 nuts (H1)
Step 4
Attach the legs of the headboard (B) to the bed frame or mounting bracket by fixing them together through the 2 holes in the bed frame and the vertical slot in the leg using
4 small bolts (H4), 8 washers (H2) and 4 nuts (H1)
advertisement