advertisement
▼
Scroll to page 2
Tel: 323-982-8955 | 1, New installations | | 3, Accessory list . Website: www.boyelliving.com Boyel TLiviNg Email: [email protected] NOTE!!! , | a 1. Supply lines should be purged to clean impurities before connecting the unit. 2. The hot water supply should be connected to the left and the cold water supply to the right, when viewed from the operating position. If this is not taken into account can cause permanent damage to the cartridge. 3. Screw connections and test for leaks. 4. Using a spirit level on the cams, the mixer align horizontally, vertically and parallel to the wall. 5. Warm reminder: In the cold areas or the indoor temperature is less than 39°F in Winter, if no using the faucets for a long time, please turn E ‘ : à No Description Qty off the inlet water valve and drain the remaining water 7 Pressure balanced valve 7 inside the supply pipe, which can avoid the faucet damage > Cover boarc 1 caused by the expansion of the frozen water. 3 Diverter knob 1 4 Cartridge handle 1 | 2, Installation Preparation | 5 Hand shower holder 1 INSTALLATION MANUAL | nn : Snowe Tose 1. Read the instructions carefully before installing. uf and Some! | | = 8 Shower head 1 SHAMANDA Luxury Shower Set 2. The installation must be performed by a qualified person 9 Shower arm 1 . | 10 Decorative cover 1 | | 3. Installation tools: \ 6 Rp 11 Allen-Key i Style may vary by model, but the installation ways are the same © 1 12 Screws bag 1 | 4, Pressure-balanced valve | | 5, Chiseling wall diagram | | 6, Pipe-connection diagram | Unit:inch | a — P lo > | 2.36" —3.14" Shower head Zz outlet Mr „th | walls | |_ Tiles я | = == = [в : : Hot water | IN NR 1.) The both side screws can 2.) When the cartridge need to be inet > (6 eo) < Cold water но be screwed deeper to change, just screw the screws Y inlet © | adjust the water flow deepest, so that you do not need ! to turn off the main switch of your water Hang shower 3 4 | 7, Water test and leak detection | 1. After connecting all pipes, please dis-assembling the plastic protection cover, and switch on/off the cartridge, check all connections without any leakage, and all connections connectingtothe required functional outlets. 2.Re-install the plastic protection cover to the valve. 8, Wall tiling program 1. Use aparallel ruler to make sure the wall and valve being parallel. Wall 1 E Cover and handle installation 1. Take off the plastic protection cover. 2.Put the cover board on the valve and tight the handle firmly SARK en | 11, Shower installation | 12, Cleaning & Maintenance To keep the product clean&shining, follow the steps as follows: 1. Flush with clean water& dry with soft cloth only. 2. If any dirt, clean with soft liquid or transparent glass detergent. 3. Do not use any scrubbing detergent, polisher, sand-cloth, paper tissue or scraper. 4. Do not use acid detergent, insoluble&grain-like detergent or soap. | 13, Important notice | For Installation Support, Missing Parts or Damaged Product, please do not return, just send email to [email protected] to get FREE parts or product ! 11
advertisement