A
Kobe T-Base Assembly and Installation
(MKTRCT4824, MKTRCT6024, MKTRCT7224, MKTRCC4824, MKTRCC6024, MKTRCC7224)
Organize your parts. You will need a phillips head screw driver, pencil and measuring tape, drill(optional).
Two people are required for assembly.
Parts & Hardware: (Depending on the product, PART C will be 4 Glides OR 4 Casters)
A: Table Top • B: T-base Leg(2) • C: Glides/Casters(4) • D: Screw(16)
B C D
Step 1:
Screw 2 Glides/Casters
(C)
into each T-base
Leg
(B)
.
B
C
Step 2:
On a clean flat surface, place desired finish of
Table Top(A) face down
.
Step 3:
Prepare your Template (INCLUDED) by taping both template pages to one another on the dashed line.
EXAMPLE
4”
LINE UP TOP EDGE OF SECOND SHEET HERE.
9.5”
ALIGN THIS CORNER
WITH TABLE TOP
CORNER
STEP 4a: Follow the Assembled Template for Leg Placement. The template for attaching the legs should be aligned as shown below.
Leg #2
NOTE:
Edges of template align with edges of table.
Leg #1
STEP 4b: When T-base Leg is aligned with the template, Mark the four holes on Table top(A).
Step 5:
Attach the T-base Leg(B) to the Table Top(A) using 8 Screws(D) per Leg.
B
A
IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions please call Regency Office Furniture at 1-866-816-9822
4”
LINE UP TOP EDGE OF SECOND SHEET HERE.
ALIGN THIS CORNER
WITH TABLE TOP
CORNER
9.5”
