advertisement
Overview and Specification
Yellow
Black
• Size: Φ28*53.1
• Red wire from Pot: VCC
• Yellow wire from Pot: SIGNAL
• Black wire from Pot: GND
Installation
Step 1
① : Unscrew the screw and take the top stick out.
② : Take this out and assemble the extended stick.
Step 2
① : Put the spring washer into the base of the lever.
② : Screw the lever in the base as tightly as possible.
If the gimbal is loose after installation , the springs of the gimbal could be replaced by the spare ones.
Login to continue