Shenzhen Wondersound Technology GM3 True Wireless Earbuds User Manual

1

Earbuds battery capacity：35mAh

Duration : about 5.5 hours ( headset）

Charging time : about 1.5 hour ( headset）

Battery capacity : 250mAh

Charging time : about 2.5 hours

2

2

2

Charging of charging box: the white light is always on during charging of charging box

When the box is fully charged: the green light is always on

When the cover is opened or closed, the green indicator will light up for 5 seconds

When the cover is opened or closed, the red indicator will flash for 5 seconds

Mode 1: Put the earphone back into the charging box and close the box cover

Mode 2: When the device is not connected to the smart device, the earphone will shutdown automatically after 5 minutes

Method 1: Open the Bluetooth list of smart devices, search for "Moi P1“ and Connection

(support for single ear use).

Set up the

Bluetooth

My device

P1

Bluetooth

Pairing status: Voice prompt: "Pairing"

Connected successful: Voice prompt: "Connected"

L R

Pause / play: double click the headset

Last song: three hits on the left headphone

Next song: three clicks on the right headset

ANC

L R Right ear operation in binaural mode

Transparent / ANC on / ANC off: press and hold the right ear for 3 seconds

4

Answer an incoming call: double click any headset

End the call: double click any headset

Rejected call: press either earphone for about 2 second

Left headset operation

In addition to the call status, touch the left headset for 3 seconds to activate the voice assistant function (you need to support the connected smart device)

Turn on / off the voice assistant: press and hold the left ear for 3 seconds

5

1

2

3

4

6 7

Username

Address

WARRANTY CARD

8

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

9

P1

FCC ID:2AYBH-MOIP1