IN-LINE COLOR MIXING NOZZLE

Model NZC1

For use with Helix Sets #105084 and #107331

INSTRUCTION MANUAL

September 2011

IMS Company

10373 Stafford Road

Chagrin Falls, OH 44023-5296

© Copyright 2011 IMS Company. All rights reserved.

1

Telephone: (440) 543-1615

Fax: (440) 543-1069

Email: [email protected]

Website: www.imscompany.com

An ISO 9001:2008 Registered Quality Company

In-Line Color Mixing Nozzle Assembly Instructions

1.

2.

3.

4.

5.

6.

7.

8.

Gather the following parts to complete the In-Line Color Mixing Nozzle:

A.

In-line Color Mixing Nozzle Body or

B.

Helix Set (2 flat face, 2 right flutes, 3 left flutes), IMS #105084

#107331

C.

D.

Any additional helixes that need to be inserted into the Nozzle Body

Nozzle Tip

Remove Nozzle Body, Tip, and Helixes from protective plastic coating or sleeve.

Insert one flat face Helix into the 0.50” bore with the flat face facing toward the rear of the Nozzle Body.

Insert one right flute Helix into the 0.50” bore.

Insert one left flute Helix into the 0.50” bore.

Repeat Steps 4 and 5 until there are no remaining left or right Helixes.

Insert the final flat face Helix into the 0.50” bore with the flat face facing toward the front of the Nozzle Body.

Thread the Nozzle Tip into the front of the In-Line Nozzle Body.

ASSEMBLY LAYOUT

FF= FLAT FACE HELIX

R=RIGHT FLUTE HELIX TIP=NOZZLE

TIP FF L R L R L FF

NOZZLE

FF L R