CADEM Viking - 100 Machine Control System Settings Guide

Viking - 100
NCnet 7.0 settings
Set these parameters on the machine
Baud rate
Parity
= 2400
= Even
To set the controller in the Drip-feed mode
Drip feed is not available on this controller.
Set these parameters on the PC
Machine details
Machine name
Control system
Machine ID
Communication Channel
Port Number
Folder for PC to Machine transfer
Folder for Machine to PC transfer
Baud rate
Data bits
Parity
Stop bits
Handshake
MCH-1
Viking - 100
01
Serial Port
Any free COM port)
Transmit directory
Receive directory
2400
7
Even
2
Hardware
General settings
Ignore this. Leave all data as it is.
Transmit settings
Wait period at start of transmission
Wait period after transmitting program
Size of transmit packet
Delay period after each packet
Wait for XON before transmitting program
Transmit comments?
Comment start character
Comment end character
Translation mode for CR
Translation mode for LF
Acknowledgement and error (Mode of transmission)
ACK/ERR Message start text
ACK/ERR Message start text
Filter Null Character
30.00
5.0
0
0
No
Yes
(
)
Transmit as CR
Transmit as LF
Transmit descriptive message
%1234
%
Yes
Page 1 of 2
NC Program settings
Program start string
Program end string
Characters to transmit at start
Characters to transmit at start
Number of Characters
Number of Characters
Receive settings
Wait period before receiving program
Wait period after receiving program
Transmit XON before transmitting program
Auto compare and save
Acknowledgements and errors
Translation mode for CR
Translation mode for LF
Ignore control characters other than CR-LF
Save Program between Start Characters and End Characters
Start Program reception after these characters are received
End Program reception after these characters are received
45.0
5.0
No
Yes
Transmit descriptive messages
Ignore
Save as CRLF
Yes
No
To set the PC in the Drip-feed mode
Drip feed is not available on this controller.
Cable connections
If the PC has 9 pin connector
Null modem
PC
9 pin
Full Handshake
CNC
25 pin
1
2
3
4
5
6
7
8
8
2
3
20
7
6
4
5
PC
9 pin
CNC
25 pin
1
2
3
4
5
6
7
8
8
2
3
6
7
20
5
4
If the PC has 25 pin connector
Null modem
PC
25 pin
8
2
3
20
7
6
4
5
CNC
25 pin
8
3
2
20
7
6
4
5
Full Handshake
PC
25 pin
8
2
3
20
7
6
4
5
CNC
25 pin
8
3
2
6
7
20
5
4
Note: There is no standard cable configuration for this controller. Please refer the machine
user manual
Page 2 of 2
">