BOSTONtec CPU12 Mounting Instructions

Under Work Surface CPU
Holders
Tool List
#2 Phillips screwdriver
3/8” nut driver or wrench
Impact driver with #3 Phillips bit
C
Part # CPU12, CPU20 - Under Work Surface CPU Holder
D
Item
F
1
Components
Qty
A
#10-32 x ½” Phillips pan head machine screw
6
B
#10-32 Kep nut
6
C
CPU holder track mounting bracket
1
D
CPU holder track
1
E
#12 x ¾” Phillips pan head sheet metal screw
8
F
CPU holder
1
G
Quick track end cap
1
H
Quick track pin
2
Align the holes on CPU holder track (D) with the holes on CPU holder track mounting bracket (C) as
shown in Fig-1. Use six #10-32 x ½” Phillips pan head machine screws (A) and six #10-32 Kep nuts (B) to
connect CPU holder track mounting bracket (C) and CPU holder track (D).
C
B
D
A
1
Fig-1
Under Work Surface CPU
Holders
2
Mount the CPU holder track mounting bracket (C) with CPU holder track (D) attached to the underside of
the work surface using eight #12 x ¾” Phillips pan head sheet metal screws (E) (Fig-2).
*Ensure rear tab stops on track are facing the back of the table (Fig-3)
C
D
E
Fig-2
D
Rear tab stops
Fig-3
2
Under Work Surface CPU
Holders
Mounting Rail
Width Knob
D
G
Upper Assembly
Height Lock
Side Bracket
H
Base
Fig-4
3
a
b
4
Install CPU into the holder
Loosen Width Knob and slide
Side Bracket outward. Loosen
Height Lock and slide Upper
Assembly to highest position.
Center CPU on the Base.
Lower Upper Assembly until
it lightly touches top of CPU.
Tighten Height Lock. Push
Side Bracket inward until
it fits tightly against CPU.
Center Mounting Rails above
CPU. Tighten Width Knob.
3
Install CPU holder (with CPU in it) into Track
a
Align Mounting Rails of the CPU holder with
front edge of CPU Holder Track (D). Slide CPU
holder unit into Track.
b
Slide Quick Track End Cap
(G) into Track (D). Insert
Quick Track Pins (H) into
Quick Track End Cap (G)
(Fig-4), rotate them 90
degrees to lock (Fig-5).
H
H
D
Fig-5
5
Remove CPU from CPU Holder.
*It is important that you remove the CPU
holder with CPU in it from the CPU Holder
Track first.
a
Rotate Quick Track pins (H) 90 degrees.
Remove Quick Track End Cap (G) from CPU
Holder Track (D). Slide CPU holder (with CPU in
it) off the Track (D).
b
Loosen Width Knob and Height Lock of the
CPU holder. Remove CPU from holder.
">