RUL-C Series
LED Rural Utility Luminaire
Reflector/Refractor Kit and CutOff Shield Kit
IMPORTANT SAFEGUARDS
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER - Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant l’installation.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
TO INSTALL:
1 Luminaire With Reflector/Refractor Accessory
Luminaire
Optic
(2) Luminaire Accessory
Mount
Reflector/
Refractor
(2) Hinges
Luminaire
Optic
Luminaire With Cutoff Shield Accessory
(2) Luminaire Accessory
Mount
(2) Hinges
Cutoff Shield
(2) Luminaire
Accessory Mount
Groove of Luminaire
Accessory Mount
Hinge Tab in
Locked Position
INSTALLATION
NOTE: There are two different types of shields, a Reflector/Refractor and Cutoff Shield. These instructions are for both types.
STEP 1:
Place the accessory over the luminaire optic by hanging the accessory hinges from the grooves in the Luminaire Accessory Mount on each side of the luminaire housing. See Figure 1.
STEP 2:
Secure the accessory in place by pulling down on both Hinge Tabs until they lock in place. Adjust the accessory as needed to be centered on the optic.
See Figure 1.
© 2023 Cree Lighting ® , A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree ® and the Cree logo are registered trademarks and the Cree SmartCast Technology logo is a trademark of Cree, Inc. www.creelighting.com
1 of 1 LPN05497X0003A0_A
