VISSEM VSOF-OTB-H 12C/24C Optical Termination Box Manual

OPTICAL TERMINATION BOX

VSOF-OTB-H-12C/24C Manual

1. Marking a Cutting Point

Mark a sheath removing point on the cable with a piece of tape at a 100cm point from the cable cut end.

2. Sheath Removing

Remove the cable sheath from the marked point by using a sheath stripper

Remove all plastic tape.

Component List

Items

Protection Tube

Heat shrinkable sleeve

Key Lock

Cable tie

Cord Protection Tube

Unit

EA

EA

EA

EA

EA

Q’ty

4 X Splice Tray

Q’ty

4 X Splice Tray

Nuber of cores Nuber of cores

2 2

4 X Splice Tray

12C=8

4 X Splice Tray

24C=16

3. Cutting Tension Member

Leave 6cm from the cable and cut off the tension member.

4. Removing Loose Tubes

Leave about 4cm from the cable sheath end and remove the rest of the loose tube.

Clean the cut area by using jelly cleaner.

Note. Be sure not to damage the fiber optics.

5. Inserting Unit Protection Tube

Insert fibers into the unit protection tubes carefully all the way up to the point where loose tubes end.

Wrap the tape around the end point of protection tube at cable side.

6. Inserting Fiber Optic Cable

Insert the cable into the cable-gland Tighten lid of cable-gland till fixing

Feeder cable

7. Fixing Fiber Optic Cable

Insert the tension member into the T/M fixing bracket and tighten them together by using a screwdriver

Secure the cable to the center of the

Susband Bracket by using a susband

8. Routing Protection Tube

Route protection tubes to the splice tray inlet and secure the protection tubes on the splice tray inlet by using cable tie.

9. Pigtail Connection

Connect the pigtails to the adapters by turns on the adapter panel.

VISSEM OTB-H Menual Rev.0 TEL: 82-31-283-7852 FAX: 82-31-283-7844

All rights reserved by VISSEM Electronics Co. Ltd.

Optical Termination Box (VSOF-OTB-H)

User Manual (Rev.0)

10. Routing Pigtail

Route cord and guide them into stacked

Splice tray

Insert cord into splice tray inlet and tie

Together by suing cable ties

Apply the same way to the apposite side

11. Splicing

Splice fibers in accordance with splicing method to be approved

13. Recording

Record each splice on the index card on the lid.

14. Finishing the Termination Box

Close the splice tray supporter and fasten

It boy using a captive screw bolt

Push the door back to the shelf and lock them by using a key to be provided.

The OPTICUBE has been made under strict quality control and tests. Our products passed several inspection criteria, specifications and other certification standards.

The technical facts of the products are based upon reliable information, but the user should consider the usage and applicability of the product before operation. Sellers do not assume any liability resulting from improper use. The contents of this manual are made in lieu of all warranties, but sellers do not take the responsibility for any damage caused by users or any statements unrelated to this manual.

VISSEM Electronics

235-2, Deokpyeong-ri, Majang-myeon, Icheon-city,

Gyeonggi-do, Korea 467-812 www.opticube.co.kr

Email: [email protected]

Tel: 82-31-283-7852 Fax: 82-31-283-7844

©VISSEM OPT-M0711 Printed in Korea

VISSEM OTB-H Menual Rev.0 TEL: 82-31-283-7852 FAX: 82-31-283-7844

All rights reserved by VISSEM Electronics Co. Ltd.