Kimball 2633272 Xsede - Above Surface Panel to Panel Jumper Installation Assembly Instructions

Xsede
™
Assembly Instructions
Above Surface Panel to Panel
Jumper Installation
Tools Required

N/A
Hardware Required
1-Pass Through Or Electrical Kit
1-Panel to Panel Jumper
Installation
1.
2.
3.
4.
5.
Unpack panel to panel jumper. (Take care to insure that
proper jumper is used as specified by both the floor and
elevation plan views.)
Insure that Either the electrical kit or pass through kits is
already installed.
Pass through and frame assembly needs to be completed
before going on.
Install the pass through as shown in Figure A below.
Immediately following this, install (Panel to Panel
jumper)/(Connector Jumper).
Figure A
Figure B
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part 2633272, Revision -
1