Kimball 2633268 Xsede - Above Surface Pass Through Installation Assembly Instructions

Xsede
™
Assembly Instructions
Above Surface Pass Through
Installation
Tools Required

N/A
Hardware Required
1-Pass through Kit
Installation
1.
2.
3.
4.
5.
Unpack Pass through kit and J-Hooks. (Take care to insure that proper kit is used as specified by both the floor
and elevation plan views.)
Insure pass through kit is being used in above surface
application.
Pass through and frame assembly needs to be completed
before going on.
Install the pass through as shown in Figure A below.
Immediately following this, install (Panel to Panel
jumper)/(Connector Jumper).
Figure A
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part 2552384, Revision -
1