Displayit Graffiti Counter Assembly Instructions

Graffiti Counter
Assembly Instructions
Corner Hub
En
dc
ap
Ch
an
ne
l
Ba
r
Channel Bar
Adjustable
feet
1. Expand the frame with the
adjustable feet pointed down.
Endcap
Channel
bar
2. Lock the two metal
support brackets to secure
the frame open.
3. Install the 4 front channel bars
and rear 4 back channel bars.
The thinner edge goes toward the
inside of the frame.
4. Snap the four endcap channel
bars to the top and bottom sides
of the frame.
“X” Shaped
Strap goes in back
Rear
Vertical
Channel
Bar
Front
Vertical
Channel
Bar
Front
Horizontal
Channel
Bar
Diagram showing the locations
of the channel bars required.
5. Install the wrap-around fabric graphics.
See the following page for detailed graphic
installation.
7. Insert the shelf, latching the metal
hooks onto the support brackets on
each side of the frame.
6. Set countertop on top (making sure the
frame nubs go into the recesses).
Updated 4/17/2024
Graffiti Counter
Assembly Instructions
Graphic Installation Instructions
Handle graphics with care with clean hands in a
clean environment. Clean cloth or latex gloves are
recommended.
Caution! Installing silicone-edged graphics is techniqe sensitive; Practice will
shorten installation time.
Stitched edge
goes in first
SEG
groove
Start in
the corner
How to Install SEG Graphics:
Turn and tuck the side of the graphic with the silicone welt into the SEG groove. The
stitched ege goes into the groove first.
INCORRECT
Pull
CORRECT
Silicone
Bulge
Press While
Sliding Hand
Tuck
Pulling on the silicone welt during installation stretches the silicone and creates a
bulge in the silicone welt that is difficult to correct smoothly.
Tuck
Tuck
A series of tucks reduces excess silicone.
Installing Graphics with Wrap-Around Endcaps
1. Tuck the graphics into each
corner where there is a gap in
the silicone welt.
The silicone welt tucks into the
SEG groove facing forward from
the front of the frame.
2. Complete tucking the
top and bottom of the
front of the graphic.
3. Wrap the endcap around the
sides of the counter and tuck
into the rear side vertical SEG
grooves.
Complete endcap installation by
tucking the remaining silicone
into the SEG grooves.
Updated 4/17/2024
">