CH-1507TX & RX

HDMI to CAT5e/6 with LAN/IR/RS-232/PoE

DISCLAIMERS

The information in this manual has been carefully checked and is believed to be accurate. Cypress Technology assumes no responsibility for any infringements of patents or other rights of third parties which may result from its use.

Cypress Technology assumes no responsibility for any inaccuracies that may be contained in this document. Cypress also makes no commitment to update or to keep current the information contained in this document.

Cypress Technology reserves the right to make improvements to this document and/or product at any time and without notice.

COPYRIGHT NOTICE

No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or any of its part translated into any language or computer file, in any form or by any means— electronic, mechanical, magnetic, optical, chemical, manual, or otherwise—without express written permission and consent from

Cypress Technology.

© Copyright 2011 by Cypress Technology.

All Rights Reserved.

Version 1.1 August 2011

TRADEMARK ACKNOWLEDGMENTS

All products or service names mentioned in this document may be trademarks of the companies with which they are associated.

SAFETY PRECAUTIONS

Please read all instructions before attempting to unpack, install or operate this equipment and before connecting the power supply.

Please keep the following in mind as you unpack and install this equipment:

• Always follow basic safety precautions to reduce the risk of fire, electrical shock and injury to persons.

• To prevent fire or shock hazard, do not expose the unit to rain, moisture or install this product near water.

• Never spill liquid of any kind on or into this product.

• Never push an object of any kind into this product through any openings or empty slots in the unit, as you may damage parts inside the unit.

• Do not attach the power supply cabling to building surfaces.

• Use only the supplied power supply unit (PSU). Do not use the PSU if it is damaged.

• Do not allow anything to rest on the power cabling or allow any weight to be placed upon it or any person walk on it.

• To protect the unit from overheating, do not block any vents or openings in the unit housing that provide ventilation and allow for sufficient space for air to circulate around the unit.

REVISION HISTORY

VERSION NO.

DATE DD/MM/YY SUMMARY OF CHANGE

VR0 21/10/13 Preliminary Release

CONTENTS

1. Introduction ............................................ 1

2. Applications ........................................... 1

3. Package Contents ................................ 1

4. System Requirements ............................ 1

5. Features .................................................. 2

6. Operation Controls and Functions ....... 3

6.1 Transmitter Front and Rear Panels ..3

6.2 Receiver Front and Rear Panels .....4

6.3. IR Cable Pin Assignment.................5

6.4. D-Sub 9 Pin Definitions ....................5

7. Connection Diagram ............................ 6

8. Specifications ........................................ 7

8.1 CAT5e/6/7 Cable Specification .....8

9. Acronyms ............................................... 8

1. INTRODUCTION

The HDMI with RS-232 over Single CAT5e/6/7 Transmitter and Receiver set can send uncompressed audio/video over a single run of

CAT5e/6/7 cable up to 100 m with 48V PoE from Transmitter (PSE) to

Receiver (PD) side and the added benefit of control through the builtin RS-232 and IR ports and a bi-directional LAN connection.

2. APPLICATIONS

• 48V PoE from Transmitter (PSE) to Receiver (PD)

• Household entertainment sharing and control

• Lecture room display and control

• Showroom display and control

• Meeting room presentation and control

• Classroom display and control

3. PACKAGE CONTENTS

• 1×HDMI to CAT5e/6/7 (with LAN/IR/RS-232) Transmitter

• 1×CAT5e/6/7 to HDMI (with LAN/IR/RS-232) Reciever

• 1×IR Blaster

• 1×IR Extender

• 1×48 V/0.83 A DC Power Adaptor

• Operation Manual

4. SYSTEM REQUIREMENTS

Input HDMI source equipment such as DVD/Blu-ray player and HDMI equipped output display (TV or monitor).

1

5. FEATURES

• HDMI with 3D, 4K×2K support, HDCP & DVI Compliant

• Supports CEC bypass

• Simultaneous transmission of uncompressed data over a single

100 m/328 ft CAT5e/6/7 cable

• Uncompressed video 1080p, 60 Hz, 36-bit

• Audio support up to 7.1CH & Dolby TrueHD, DTS-HD

• Supports audio sampling rate 32kHz ~192kHz

• 5Play™ convergence: HDMI, LAN, PoE & Control (IR & RS-232)

• Support standard 48V from Transmitter (PSE) to Receiver (PD)

• Installation Friendly

Note:

1. This system was tested with CAT5e/6/7 cables, results may vary with cables of a different specification.

2. The standard 48V PoE function is designed for powering compatible Receiver units only—non-PoE Receivers will need their own power supply. Receivers of another brand may not be compatible.

3. Displaying HMDI 3D and 4Kx2K contents, equivalent source signal and HDMI cable are required in order to secure the quality.

2

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter Front and Rear Panels

Front

RS-232 IN

Transmitter

HDMI IN

POWER IR1

BLASTER

Rear

LINK

1

LAN

HDMI to CAT5e/6/7 with LAN/IR/RS-232

2 3 4

DC 48V

5 6

IR2

EXTENDER

7 8

CAT5e/6/7 OUT

9

1

HDMI In: Connect to HDMI source equipment such as a DVD or Bluray player.

2

LAN: Connect to an internet or network connection.

3

RS-232 In: Connect to a PC or Laptop with D-Sub 9 pin male cable for the transmission of RS-232 commands.

4

Power LED: This blue LED will illuminate when the device is connected to a power supply.

5

DC 48V: Plug the 48 V DC power supply into the unit and connect the adaptor to an AC outlet.

6

IR 1 Blaster: Connect to the supplied IR Blaster cable for IR signal transmission. Place the IR Blaster in direct line-of-sight of the equipment to be controlled.

7

IR 2 Extender: Connect to the supplied IR Extender cables for IR signal reception. Ensure that remote being used is within the direct line-of-sight of the IR Extender.

8

Link LED: The yellow LED will illuminate when both the input source and output display signals are connected through CAT cable.

When it blinks regularly it states the display is NOT sending signals to receiver but the transmitter and receiver are linked and if it blink irregularly it states an error has occurred.

9

CAT5e/6/7 Out: Connect to the Receiver unit with a Single

CAT5e/6/7 cable for transmission of all data signals.

3

6.2 Receiver Front and Rear Panels

Front

RS-232 OUT

Receiver

HDMI OUT

POWER IR2

BLASTER

Rear

LINK

1

LAN

CAT5e/6/7 to HDMI with LAN/IR/RS-232

2 3 5 4

IR1

EXTENDER

6 7

CAT5E/6/7 IN

8

1

HDMI Out: Connect to a HDMI equipped TV/monitor for display of the HDMI input source signal.

2

LAN: Connect to a PC or Laptop to the Internet or network connection.

3

RS-232 Out: Connect to the device that is to be controlled (via

D-Sub 9 pin female cable) by RS-232 commands.

4

Power LED: This blue LED will illuminate when the device is connected to a power supply.

5

IR 2 Blaster: Connect to the supplied IR Blaster cable for IR signal transmission. Place the IR Blaster in direct line of sight of the equipment to be controlled.

6

IR 1 Extender: Connect to the supplied IR Extender cables for IR signal reception. Ensure that remote being used is within the direct line-of-sight of the IR Extender.

7

Link LED: The yellow LED will illuminate when both the input source and output display signals are connected through CAT cable.

When it blinks regularly it states the display is NOT sending signals to receiver but the transmitter and receiver are linked and if it blinks irregularly it states and error has occurred.

8

CAT5e/6/7 In: Connect to the Transmitter unit with a Single

CAT5e/6/7 cable for transmission of all data signals.

4

6.3. IR Cable Pin Assignment

IR Blaster

1

Power 3.3V

2

IR Blaster Signal

3

NC

IR Extender

1

IR Signal

Power 3.3 V

2

3

Grounding

6.4. D-Sub 9 Pin Definitions

Pin Define TX / RX

7

8

5

6

9

3

4

1

2

N/C

TxD / RxD

RxD / TxD

N/C

GND

N/C

N/C

N/C

N/C

5

7. CONNECTION DIAGRAM

3m

DVD or Blu-ray Player

7m

Internet Modem or Router

3m

60°

1.5m

60°

IR Blaster

Power

Supply

HDMI CAT5e/6

RS-232 IN

Transmitter

HDMI IN

POWER IR1

BLASTER

LAN

HDMI to CAT5e/6/7 with LAN/IR/RS-232

DC 48V

IR2

EXTENDER

LINK

CAT5e/6/7 OUT

RS-232

TX

IR Extender

RS-232 Equipped

PC or Notebook

IR Extender

3m

7m

60°

3m

IR Blaster

1.5m

60°

HDMI

POWER IR2

BLASTER

IR1

EXTENDER

LINK

CAT5E/6/7 IN

RS-232 OUT

Receiver

HDMI OUT

LAN

CAT5e/6/7 to HDMI with LAN/IR/RS-232

RX

RS-232

RS-232 Equipped

HDMI Switcher

CAT5e/6

TV or Monitor

Notebook

6

8. SPECIFICATIONS

Video Bandwidth

Ethernet Speed

Transmitter

Inputs

Outputs

Receiver

Inputs

Outputs

HDMI In/Out Cable

Distance

300MHz / 10.2Gbps

100 Mbps

1×HDMI, 1×IR Extender,1×RS-232, 1×LAN

1×CAT5e/6/7, 1×IR Blaster

1×CAT5e/6/7, 1×IR Extender

1×HDMI, 1×RS-232, 1× IR Blaster, 1× LAN

In: Up to 15 M/1080p@8-bit or

6M/1080p@12-bit

Out: Up to 15M/1080p@8-bit or

10M/1080p@12-bit

Up to 100 Meters

CAT6 In/Out Cable

Distance

HDMI In/Out Supports

Resolution

IR Frequency

ESD Protection

480i~1080p@50/60, 1080p@24, 3D,

4Kx2K@24/25/30 VGA~WUXGA

30~50 kHz

Human Body Model:

Power Supply

±8 kV (air-gap discharge)

±4 kV (contact discharge)

48 V/0.83 A DC (US/EU Standards, CE/FCC/

UL certified)

Dimensions

Weight

Chassis Material

Silkscreen Color

Power Consumption

102 mm (W)×113 .5 mm (D)×25 mm (H)/TX

102 mm (W)×107 mm (D)×25 mm (H)/RX

262 g (TX), 262 g (RX)

Aluminum

Silver

15 W

Operating Temperature 0 °C~40 °C/32 °F ~104 °F

7

Storage Temperature

Relative Humidity

−20 °C~60 °C/−4 °F~140 °F

20~90 % RH (non-condensing)

8.1 CAT5e/6/7 Cable Specification

Cable

Type

Range

CAT5e/6/7 100 m

Pixel clock rate

Video Data

Rate

<=225 MHz <=5.3 Gbps

(HD Video)

70 m/

CAT5e/6

100 m/CAT7

>225 MHz > 5.3 Gbps

(Ultra HD

Video)

Supported

Video

Up to 1080p,

60 Hz, 36 bits,

3D (data rates lower than 5.3

Gbps or below

225 MHz TMDS clock).

4K2K, 30Hz video formats

9. ACRONYMS

ACRONYM

CAT5e

COMPLETE TERM

Category 5 Cable

CAT6

CEC

DVI

HDCP

HDMI

IR

PD

PSE

Category 6 Cable

Consumer Electronics Control

Digital Visual Interface

High-bandwidth Digital Content Protection

High Definition Multimedia Interface

Infrared

Powered Device

Power Sourcing Equipment

8

CYPRESS TECHNOLOGY CO., LTD

Home page: http://www.cypress.com.tw

20130524 MPM-CH1507