Conrad Electronic 4 ports USB 2.0 hub individually connectable, + LED indicator lights, 1687470 Owner's manual

1 USB-Port
4
1
6
2
5
3
• USB-Hub
USB-Hub
*1687470_v1_0618_fl01_02_m_4L(2)
Operation
Make sure that all connected devices do not exceed the max. possible supplied
current of the power source.
• Connect the USB plug (6) to an available USB port on your computer.
Operating Instructions
• Connect a USB device to an available USB port (1) on the hub.
Switchable 4 Port USB 2.0 Hub
• Turn the power on or off for each port using the corresponding switch (2).
• A port LED (3) will indicate that a USB port is powered on.
Item No. 1687470
Power Adaptor (Not Included)
Intended Use
This device can connect up to four additional USB 2.0 devices to your computer. It is backwards
compatible with USB 1.1 and supports plug & play / hot-swapping. Each port has a hardware
on / off power switch.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged. In
addition, improper use can result in short circuits, fires, or other hazards. Read the instructions
carefully and store them in a safe place. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery Content
• USB hub
Make sure that all connected devices do not exceed the max. possible supplied
current of the power source.
• The hub functions in ”Bus-Powered-Mode”. This means that the 500mA current supplied by
the computer is divided by 4 ports.
• If a power adaptor (5 V/DC, min. 2000 mA) is used, all 4 ports can supply a current of 500
mA. Refer to “Technical Data” section for power adapter requirements.
• Connect the power adaptor to the DC power port (5).
You can connect up to four USB devices to the hub. The hub supports plug & play
and hot-swapping (device drivers are automatically recognized and the devices
themselves can be removed while the OS is running).
USB 2.0 is backwards compatible with USB 1.1. To reach USB 2.0 transfer speeds
(480 MBit/s, 60 MByte/s) the connected device must also support USB 2.0. The data
transfer rate is split across the 4 ports.
Care and Cleaning
• Operating instructions
• Disconnect the device from your computer and disconnect all peripherals.
Up-to-date Operating Instructions
• If it is hot, wait for it to cool down to room temperature.
Download the latest operating instructions at www.conrad.com/downloads or
scan the QR code shown. Follow the instructions on the website.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as
they can cause damage to the housing and malfunctioning.
• Clean the product with a dry, fibre-free cloth.
Explanation of Symbols
The symbol with the exclamation mark in the triangle is used to indicate important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
Safety Instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become
dangerous playing material for children.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product in accordance
with applicable regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the
environment.
Technical Data
USB Hub
Operating voltage.......................... 5 V/DC (via USB), 500 mA
Connections................................... 4
USB interface................................ 2.0 / 1.1
• Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, steam and solvents.
Transfer rate.................................. Max 480 Mbit/s
• Do not place the product under any mechanical stress.
Operating conditions...................... -10 to 60 °C, 20 – 80 % relative humidity
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
Storage conditions......................... -20 to 80 °C, 10 – 90 % relative humidity
-- is visibly damaged,
-- is no longer working properly,
-- has been stored for extended periods in poor ambient conditions or
-- has been subjected to any serious transport-related stresses.
Cable length.................................. 44 cm (w/o plug)
Dimensions (W x H x D)................ 105 x 24 x 35.5 mm
Weight........................................... 54 g
Supported Operating Systems
Windows®, Mac, Linux
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
Power Adaptor (Not Included)
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
Plug diameter................................ 1.35 mm (inner)/3.5 mm (outer), length: 10 mm,
Output voltage/current................... 5 V/DC, min. 2000 mA
• Consult an expert when in doubt about the operation, safety or connection of the
appliance.
• Maintenance, modifications and repairs must only be completed by a technician
or an authorised repair centre.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
1 USB port
4
6
2
3
5
2 ON(I)/OFF(0)
3 Port LED
4 Power LED
5 DC power port
6 USB plug
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights
including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represents the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
*1687470_v1_0618_fl01_02_m_4L(2)
1 Port USB
2 ON(I)/OFF(0)
4
1
6
2
4 LED
d'alimentation
5
3
Nº de commande 1687470
• Hub USB
3 LED de port
5 Port
d’alimentation
CC
Entretien et nettoyage
Hub USB
Interface USB................................ 2.0 / 1.1
Windows®, Mac, Linux
*1687470_v1_0618_fl01_02_m_4L(2)
Gebruiksaanwijzing
Schakelbare 4-poort USB 2.0 hub
1 USB poort
4
1
6
2
5 DC IN-poort
6 USB-stekker
Beoogd gebruik
• USB-hub
• Gebruiksaanwijzing
3 Poort-led
4 Power-led
5
3
2 ON(I)/OFF(0)
Onderhoud en reiniging
USB-hub
Netvoedingadapter (niet inbegrepen)
Stekkerdiameter............................ 1,35 mm (binnen) / 3,5 mm (buiten), lengte: 10 mm,
Uitgangsspanning/-stroom............. 5 V/DC, max. 2000 mA
*1687470_v1_0618_fl01_02_m_4L(2)