Simrad CP32 MKII Chartplotter User Manual
Anuncio
Anuncio
$
Fyi Insert or remove C-MAP cartridges ONLY thru CHART
menu or when unit is off.
All electronic navigation equipment is subject to external factors
beyond the control of the manufacturer. Therefore such equipment
must be regarded as an aid to navigation. The prudent navigator
will, for that reason, never rely on a single source for position
fixing and navigation.
Qrswei 5H ECAA
69HQ 5revyi
$7xqvsr
Fyi Insert or remove C-MAP cartridges ONLY thru CHART
menu or when unit is off.
All electronic navigation equipment is subject to external factors
beyond the control of the manufacturer. Therefore such equipment
must be regarded as an aid to navigation. The prudent navigator
will, for that reason, never rely on a single source for position
fixing and navigation.
Qrswei 5H ECAA
69HQ 5revyi
$7xqvsr
In case someone falls overboard, press the [MOB] key
and hold for two seconds (or activate an external MOB
switch), and the system will provide you with all rele-
vant data for an efficient rescue operation.
An alarm will sound if the
function is activated from
an external MOB switch.
Press [CLR] to confirm
and reset the alarm.
The EG4display will
provide present course,
bearing and distance to
the MOB position.
Elapsed time - first in sec-
onds and then in minutes
(*=over 9999 minutes).
9yyqersgevEG4hsve
The 5@3PRdisplay will provide a graphical impres-
sion of the MOB position - a man waving his arms in
relation to the ship.
Hi[WIN] iieihvyi xyriEG4hsve
Hi[MENU], [4],exh[3]y xriEG4p xgsyxypp
Hi[MENU], [2],exh[6]yigevvriveEG4ys
syxv riiegswiexhheiyprisxgshix
EG4 E3FGT7P4G3P6 p xgsyx
KEYS TO PRESS
MOBig
MAN OVERBOARD
C241° B113°
DIST 1.89nm
TIME 8min
MOB 56°52.743N
POS 9°46.572E
Stop MOB: MENU 4, 3
WIN
2,6MENU
4,3MENU
GOTO
and hold for two seconds (or activate an external MOB
switch), and the system will provide you with all rele-
vant data for an efficient rescue operation.
An alarm will sound if the
function is activated from
an external MOB switch.
Press [CLR] to confirm
and reset the alarm.
The EG4display will
provide present course,
bearing and distance to
the MOB position.
Elapsed time - first in sec-
onds and then in minutes
(*=over 9999 minutes).
9yyqersgevEG4hsve
The 5@3PRdisplay will provide a graphical impres-
sion of the MOB position - a man waving his arms in
relation to the ship.
Hi[WIN] iieihvyi xyriEG4hsve
Hi[MENU], [4],exh[3]y xriEG4p xgsyxypp
Hi[MENU], [2],exh[6]yigevvriveEG4ys
syxv riiegswiexhheiyprisxgshix
EG4 E3FGT7P4G3P6 p xgsyx
KEYS TO PRESS
MOBig
MAN OVERBOARD
C241° B113°
DIST 1.89nm
TIME 8min
MOB 56°52.743N
POS 9°46.572E
Stop MOB: MENU 4, 3
WIN
2,6MENU
4,3MENU
GOTO
Axyh
gsyx 5
8 xhewixevexhsxssev
e
2.1 Keypad ................................. 7
2.2 Getting started...................... 9
2.3 Menu bar ............................ 11
2.4 Menu layout ....................... 12
5reexhyssyxwix
3.1 Chart menu......................... 13
3.1.1 Chart ............................... 13
3.1.2 C-MAP cartridges ........... 17
3.1.3 Chart setup 1 ................... 19
3.1.4 Chart setup 2 ................... 20
3.2 Position menu .................... 21
3.2.1 Position display............... 22
3.2.2 Course and speed ............ 24
3.2.3 Dual speed/position disp. 24
3.2.4 Decca lanes ..................... 26
3.2.5 Loran C .......................... 27
3.2.6 Position setup.................. 28
3.3 Speed diagram.................... 31
3.4 DGPS information ............. 32
Ueysx xesqesyx
4.1 Navigation menu................ 33
4.1.1 Chart/cursor navigation... 33
4.1.2 Navigation display .......... 34
4.1.3 Estimated time of arrival. 35
4.1.4 Create route by cursor..... 36
4.1.5 Waypoint navigation ....... 37
4.1.6 Make a route by using
the waypoint list .............. 37
4.1.7 Route navigation ............. 40
4.1.8 Route calculation............. 41
4.1.9 Editing of route ............... 42
4.1.10 Track navigation ........... 47
4.2 WP/Route menu ................. 48
4.2.1 Marks and waypoints ...... 48
4.2.2 Plot cursor position
on chart............................ 49
4.2.3 Plot mark or waypoint as
ship’s position ................. 52
4.2.4 Plot mark/waypoint
via WPlist ........................ 53
4.2.5 Edit mark/waypoint......... 54
4.2.6 Delete mark/waypoint ..... 56
4.2.7 Trackplotting................... 57
4.2.8 Lines (drawing) ............... 59
4.2.9 Targets............................. 61
4.2.10 Data transfer .................. 63
!Qi
5.1 Setup menu......................... 67
5.1.1 Navigation setup ............. 67
5.1.2 Setup for display colours. 70
5.1.3 Setup for speed alarm,
units & language............. 71
5.1.4 Set & drift display ........... 73
5.1.5 HSD Link setup and
data transfer ..................... 74
Refviypgyxix
8 xhewixevexhsxssev
e
2.1 Keypad ................................. 7
2.2 Getting started...................... 9
2.3 Menu bar ............................ 11
2.4 Menu layout ....................... 12
5reexhyssyxwix
3.1 Chart menu......................... 13
3.1.1 Chart ............................... 13
3.1.2 C-MAP cartridges ........... 17
3.1.3 Chart setup 1 ................... 19
3.1.4 Chart setup 2 ................... 20
3.2 Position menu .................... 21
3.2.1 Position display............... 22
3.2.2 Course and speed ............ 24
3.2.3 Dual speed/position disp. 24
3.2.4 Decca lanes ..................... 26
3.2.5 Loran C .......................... 27
3.2.6 Position setup.................. 28
3.3 Speed diagram.................... 31
3.4 DGPS information ............. 32
Ueysx xesqesyx
4.1 Navigation menu................ 33
4.1.1 Chart/cursor navigation... 33
4.1.2 Navigation display .......... 34
4.1.3 Estimated time of arrival. 35
4.1.4 Create route by cursor..... 36
4.1.5 Waypoint navigation ....... 37
4.1.6 Make a route by using
the waypoint list .............. 37
4.1.7 Route navigation ............. 40
4.1.8 Route calculation............. 41
4.1.9 Editing of route ............... 42
4.1.10 Track navigation ........... 47
4.2 WP/Route menu ................. 48
4.2.1 Marks and waypoints ...... 48
4.2.2 Plot cursor position
on chart............................ 49
4.2.3 Plot mark or waypoint as
ship’s position ................. 52
4.2.4 Plot mark/waypoint
via WPlist ........................ 53
4.2.5 Edit mark/waypoint......... 54
4.2.6 Delete mark/waypoint ..... 56
4.2.7 Trackplotting................... 57
4.2.8 Lines (drawing) ............... 59
4.2.9 Targets............................. 61
4.2.10 Data transfer .................. 63
!Qi
5.1 Setup menu......................... 67
5.1.1 Navigation setup ............. 67
5.1.2 Setup for display colours. 70
5.1.3 Setup for speed alarm,
units & language............. 71
5.1.4 Set & drift display ........... 73
5.1.5 HSD Link setup and
data transfer ..................... 74
Refviypgyxix
"Axipegsxqexhweiii
6.1 Interface settings.................75
6.1.1 Interface setup .................75
6.2 Wind instrument display.....78
6.3 Echo display .......................80
6.4 Master reset ........................82
#Axevvesyxexhisgi
7.1 Installation of CP32 MKII .83
7.2 Installation of DC30 ...........84
7.2.1 Operation of DC30 ..........84
7.3 Installation of antenna ........85
7.4 Electrical connections.........87
7.4.1 Power supply connect......88
7.4.2 Fuse .................................88
7.4.3 NMEA 0183 interface
connections .....................88
7.5 Optional connections ...........89
7.6 Maintenance .......................90
7.7 Troubleshooting procedure.91
7.8 Specifications .....................92
3ixhs3
Glossary of terms........................93
3ixhs4
List of datums .............................97
3ixhs5
TideTracker feature (only
available in US version) .............99
3ixhs6
C-MAP Port and tide
information ...............................105
Index .........................................108
CE Declaration of Conformity..112
Terms of warranty.....................113
List of Simrad Distributors
Refviypgyxix
6.1 Interface settings.................75
6.1.1 Interface setup .................75
6.2 Wind instrument display.....78
6.3 Echo display .......................80
6.4 Master reset ........................82
#Axevvesyxexhisgi
7.1 Installation of CP32 MKII .83
7.2 Installation of DC30 ...........84
7.2.1 Operation of DC30 ..........84
7.3 Installation of antenna ........85
7.4 Electrical connections.........87
7.4.1 Power supply connect......88
7.4.2 Fuse .................................88
7.4.3 NMEA 0183 interface
connections .....................88
7.5 Optional connections ...........89
7.6 Maintenance .......................90
7.7 Troubleshooting procedure.91
7.8 Specifications .....................92
3ixhs3
Glossary of terms........................93
3ixhs4
List of datums .............................97
3ixhs5
TideTracker feature (only
available in US version) .............99
3ixhs6
C-MAP Port and tide
information ...............................105
Index .........................................108
CE Declaration of Conformity..112
Terms of warranty.....................113
List of Simrad Distributors
Refviypgyxix
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
Anuncio
Relacionado
Garmin Nexus Log to Wind Data instrument
GPS ChartSounder CE32 MKII Manual
Simrad GN30 MKII DGPS Navigator Manual
