Installation. Waring Commercial WSM20L, WSM10L

INSTALLATION

UNPACKING

Unpack the mixer immediately after receipt. If the machine is found to be damaged, save the packaging material and immediately contact your source of the equipment.

WARNING

TO AVOID SERIOUS PERSONAL INJURY:

• ALWAYS install equipment in work area with adequate light and space.

• ONLY operate mixer on a solid, LEVEL, nonskid surface that is nonflammable.

• NEVER bypass, alter, or modify this equipment in any way from its original condition. Doing so can create hazards and will void the warranty.

• NEVER operate mixer without all warnings attached.

• DO NOT attempt to lift mixer alone.

INSTALLATION

1. Read this manual thoroughly before installation and operation.

DO NOT proceed with installation and operation if you have questions or do not understand everything in this manual.

Contact your local representative first.

2. Remove the corrugated box from the skid by removing the bands on the box.

NOTE:

The WSM10L and WSM20L are shipped in a wooden crate; only the bolts at the bottom of the crate on all four sides need to be removed.

3. Carefully unbolt the mixer from the skid using an 11/16" or 3/4" wrench.

4. Select a location for the mixer, keeping these points in mind:

• Floor or counter must be level.

• Easy access for maintenance and service.

• Clearance for operating controls, installing and removing agitators, bowl or attachments.

• Sufficient space for adding ingredients during mixing periods.

• Make sure rear ventilation outlet of mixer is not blocked.

7