Surround View Preview. Brigade BN360 USB (4648B)

Selecting the correct control point coordinates and control point modification

Align the control point to the outermost corner as shown below, aligning the blue lines to the triangle. The images below show before and after alignment. It is recommended to move the control point outside of the triangle to leave a clear gap between it and the triangle then work the point back towards the triangle until it meets the outer edge of the triangle.

When a control point is selected (red) with the left mouse button held drag the mouse to move the control points to the approximate position, release the left mouse button and while the control point is still red use the arrow keys on the keyboard for fine adjustment (one press of an arrow will move the control point one pixel in that direction).

Check and modify all six control points for each camera.

6.8 Surround View Preview

Clicking the “Apply AVM” button will open the surround view

“Preview” window.

If the “Calibration Error” window is displayed this indicates an error in the control point position this is generally due to one of two errors:

1. Control points are not accurately positioned, check the order and position of the control points.

2. The calibration grid is not positioned accurately, realign the calibration grid.

The preview window is shown below with the adjustment buttons labelled.

A

= Vehicle mask area

B

= Movement buttons

C

= Rotation buttons

D

= V-Ratio adjustment buttons

15