RTV1140CPX, WSM
(2) Rear Brake
BRAKES
Separating Differential Support Cover
1. Refer to "Transmission" section. (See page 2-S31.)
9Y1210293BRS0013US0
Bearing Support, Brake Disk and Friction Plate
1. Remove the internal snap ring (3).
2. Remove the bearing holder (1).
3. Remove the brake disk and friction plate.
(When reassembling)
• When installing the internal snap ring to differential support cover (2) as shown in the left photo.
• When installing the bearing holder (1) to differential support cover (2), do not forget to install the straight pin (4).
(1) Bearing Holder
(2) Differential Support Cover
(3) Internal Snap Ring
(4) Straight Pin
A: Installation Position
9Y1210293BRS0014US0
4-S13
KiSC issued 05, 2014 A
RTV1140CPX, WSM
BRAKES
Actuator, Ball and Cam Lever
1. Remove the actuator (1) and balls (2).
2. Remove the external snap ring (3) and remove the cam lever
(4).
(When reassembling)
• Take care not to damage the O-ring.
(1) Actuator
(2) Ball
(3) External Snap Ring
(4) Cam Lever
9Y1210293BRS0015US0
4-S14
KiSC issued 05, 2014 A
