C
ONFIGURING
S
YSTEM
S
ETTINGS
5
Before configuring sessions with a service provider, set up system parameters for the Megabit
Modem. The following sections show the Web pages you use to configure system parameters.
Set the:
• TFTP server IP address and network mask for performing functions such as software upgrades on page 36
• SNMP parameters on page 38
• Static NAT Entries on 40
• Static MAC Entries on 42
• Static Routes on 44
• system security on page 40
• system mode on page 48 for sessions between the modem and the service provider; select either PPP over ATM or 1483 Bridging/Routing (for Megabit Modem 700F only)
Unless specified otherwise, configuration parameters shown in this section are for example only.
Megabit Modem 400F, 500L, 600F, and 700F User Manual 35
