Hardware
H
ARDWARE
The following provides additional information about Megabit Modem 400F, 500L, 600F, and
700F such as the installation kit and modem connectors pinouts.
Installation Kit
The following items are included in the installation kit and are used to install the Megabit
Modem 400F, 500L, 600F, and 700F as shown in Chapter 3 on page 18 .
Part Description Function
Rubber feet Four black rubber feet
Grey cable Silver-satin phone cord with 4-pin modular plugs (straight-through)
Black cable CAT 5, cable with 8-pin modular plugs
(straight-through)
Power cable Power supply with optional power cord (this item is ordered dependent on the type of power supply and cord required for your location)
Screws
Grey cable and adapter
Two 6x 1 /
2
-inch sheet metal screws
Flat cable with RJ-45 connectors and a DB-9 to RJ-45 adapter.
Attaches to the base of the modem.
Connects the modem ADSL connector to the wall phone jack for access to the Internet.
Connects the modem 10/100BASE-T connector to the LAN through a hub or to a PC NIC.
Connects the modem POWER connector to the local power source.
Installs into a wall for wall-mounting modems.
Connects the RS-232 MGMT port to an ASCII terminal or a PC running terminal emulation software. Adapter assembly connects to a DB-9 connector on the PC. Then, one RJ-45 connector installs in the adapter and the other connector into the console port on the modem.
100 Megabit Modem 400F, 500L, 600F, and 700F User Manual
