•
Mounting/Removing Components
Removing and Mounting Digital Operator and Covers
NOTE: Mount the inverter after removing the front cover, digital operator and terminal cover.
• Removing front cover
Use a screwdriver to loosen the screw on the front cover surface to direction 1 to remove it. Then press the right and left sides to direction 2 and lift the front cover to direction 3.
• Mounting front cover
Mount the front cover in the reverse order of the above procedure for removal.
• Removing terminal cover when “W”
(Width) dimensions are 4.25” (108mm),
5.51” (140mm), or 6.69” (170mm)
After removing the front cover, press the right and left sides to direction 1 and lift the terminal cover to direction 2.
.
• Removing terminal cover when “W”
(Width) dimensions are 7.09” (180mm)
Use a Screwdriver to loosen the screw on the terminal cover surface to direction 1 to remove it. Then press the right and left sides to direction 2 and lift the terminal cover to direction 3.
• Mounting terminal cover
Mount the terminal cover in the descending order of the above procedure for removal.
20
• Removing digital operator
After removing the front cover, lift the upper and lower sides (section A) of the right side of the digital operator to direction 1.
• Mounting digital operator
Mount the digital operator in the reverse order of the above procedure for removal.
• Removing bottom cover when “W”
(Width) dimensions are 4.25” (108mm),
5.51” (140mm), or 6.69” (170mm)
After removing the front cover and the terminal cover, tilt the bottom cover to direction 1 with section A as a supporting point.
• Removing terminal cover when “W”
(Width) dimensions are 7.09” (180mm)
After removing the terminal cover use a screwdriver to loosen the fastening screw to loosen the fastening screw to direction 1 to remove it.
• Mounting bottom cover
Mount the bottom cover in the reverse order of the above procedure for removal.
21
